Follett Horizon Elite HCC1010WJS Manual de instrucciones de instalación - Página 5
Navegue en línea o descargue pdf Manual de instrucciones de instalación para Fabricador de hielo Follett Horizon Elite HCC1010WJS. Follett Horizon Elite HCC1010WJS 17 páginas. Self-contained chewblet ice machine
También para Follett Horizon Elite HCC1010WJS: Manual (8 páginas), Manual de instrucciones de instalación (17 páginas), Manual de inicio rápido (8 páginas)
Imprimir página
Prepare the installation site.
Provide drainage, water supply and electrical power to within 6 feet (2m) of ice
machine in accordance with local and national codes. Outdoor installation is
not recommended and will void warranty.
2.1
2.1
Installation site requirements
NEMA
5-15
Electrical
➊
• H_C1010/1410(A/W)JS 208-230/60
• H_E1010/1410(A/W)JS 230/50
‡ H_E710A, H_E1010A/W requires 15A dedicated circuit 1.50 mm
4.00 mm
wire. Plug must be provided by end user and must conform to standard EN 60 335-2-24 of the end
2
destination.
➋
Potable water supply
• 10-70 psi (69-483 kpa)
• 45 to 90 F (7 to 32 C)
• Follett recommends the use of an in-line water filtration system (item# 00130286)
• This equipment is to be installed with adequate backflow protection to comply with applicable
federal, state, and local codes
Condenser water supply for water-cooled systems
• 10 psi min.; 150 psi max. (69 kpa min.; 1034 kpa max.)
• 45 to 90 F (7 to 32 C)
• 1.5 gallons per minute (5.68 liters per minute)
Drains:
➌
3/4" Barb for silicone drain, 3/8" push-to-connect for chassis drain
• Minimum 8" radius on silicone drain line. Drain line from the ice machine must have at least
1/4" per foot pitch (6,4mm/0,3m).
DROP-IN • RIDE Technology
NEMA
6-15
‡
H_E710A
H_C1010A/W
‡
H_E1010A/W
requires 15 amp circuit
1.50 mm
2
wire
‡
H_E1410A/W
requires 20 amp circuit
2
4.00 mm
wire
H_D710A
H_C1410A/W
‡
(3/8" push-in connection, 3/8" OD tubing required)
self-contained
➊
➋
➌
➍
NEMA
1/4" per foot
6-20
(6,4 mm per 0,3 m)
1'
• H_D710AJS 115/60
• H_E710AJS 230/50
wire, H_E1410A/W requires 20A dedicated circuit
2
➌
(1/4" FPT inlet, 1/4" FPT outlet)
Site preparation
➍
3/8"
chassis
drain must
be used
2 ft. x 1" OD
silicone tubing
and ttings
provided
(Requires dedicated 15A circuit)
‡
2
5