1byone ROCK PIGEON 1-AD07US03 Manual de instrucciones - Página 12
Navegue en línea o descargue pdf Manual de instrucciones para Plato giratorio 1byone ROCK PIGEON 1-AD07US03. 1byone ROCK PIGEON 1-AD07US03 17 páginas. Belt drive turntable system
Imprimir página
Installing a New Replacement Stylus
1. Grasp both sides of the stylus holder and insert the stylus grip into the rear tab
the cartridge.
must
2. Push up the stylus holder until it clicks and locks completely in place.
l the
ed
n
Cartridge Replacement
1. Before replacement, put the stylus protector back on the stylus to prevent da
to the stylus during the replacement process.
2. Carefully remove the wire leads from the original cartridge.
3. Loosen the two screws on the headshell that are securing the cartridge and t
remove the original cartridge.
4. Mount the new cartridge to the headshell and tighten it lightly. Do not comp
tighten the screws at this moment.
5. Connect the wire leads to the new cartridge's terminals. The wire lead color
are as below:
Wire
White
Black
Red
Black
as
6. Adjust the cartridge's position to make sure it is precisely aligned on the hea
so that the stylus will be appropriately tracking within the grooves.
To achieve this, place the included paper
the turntable spindle, carefully lift the tone arm, and place the tip of the stylus
on the points marked 130mm and 250mm respectively. Fine tune the cartridg
position on the headshell until the cartridge is perfectly in parallel with the
reference lines at both points.
7. Tighten the screws completely once perfect alignment is achieved.
Stylus Holder
Do not leave any space
Channel
Left channel positive (L+)
Left channel negative (L–)
Right channel positive (R+)
Right channel negative (R-)
Stylus Grip
cartridge alignment protractor
9
over