CombiSteel 7489.4010 FR50 Manual del usuario - Página 10

Navegue en línea o descargue pdf Manual del usuario para Fabricador de hielo CombiSteel 7489.4010 FR50. CombiSteel 7489.4010 FR50 11 páginas. Ice cube machines

Imprimir página

Actions to be taken before calling authorized service.

Malfunction
Ice Maker doesn't work
The compressor stops in a short
while after it starts working.
Ice Set is cooled but the water
inside the water pool is
insufficient.
Ices are not transparent.
Ices are much smaller than they
should be.
Ices are much bigger than they
should be.
The quantity of the ice is
insufficient.
Device does not stop despite
the ice tank is full.
Probable reason
Power button is set to "Closed"
position.
The power connection is faulty.
The Ice Maker is in protection
mode.
No power in the socket.
Ambient temperature is very
high.
Grid voltage is low.
Water valve is faulty.
Mains water pressure is low.
Pool's discharge plastic seeps.
Water nozzle is blocked.
Water pool is dirty.
Pressure of the water pump is
low.
The water is blurry / dirty /
chlorinated.
Water is insufficient.
Cooling system is faulty.
Time setting is incorrect.
Sensor is faulty.
Gas leakage in the defrost
solenoid.
Water valve is faulty.
Sensor is faulty.
www.combisteel.com
Solution
Set the power button to the "Open"
position. Get the power connection
checked by qualified people.
Check the place selection instructions
of the ice maker. Ice Maker does not
receive adequate amount of air.
Check the fuse connected to the
socket.
Check the place selection instructions
of the ice maker. Ice Maker does not
receive adequate amount of air. Clean
the ventilation filter.
Get the power connection checked by
qualified people.
Contact the nearest Frozy Authorized
Service. Make sure that the mains
water pressure is greater than 1 bar.
Place the pool's discharge plastic to its
slot tightly.
Water nozzle sprayer should be
checked. The blocked nozzles should
be cleaned.
Clean the Ice Maker observing the
cleaning instructions.
Contact the nearest Frozy Authorized
Service. Use a water filter.
Place the pool's discharge plastic to its
slot tightly.
Check the water mains connection for
the water leakage.
Contact the nearest Frozy Authorized
Service.
Set the time on the electronic card to
a lower value.
Contact the nearest Frozy Authorized
Service.
Contact the nearest Frozy Authorized
Service.
Contact the nearest Frozy Authorized
Service.
10