AMPLISONIC v8 ROADSTER 30W Manual del usuario - Página 2

Navegue en línea o descargue pdf Manual del usuario para Amplificador para instrumentos musicales AMPLISONIC v8 ROADSTER 30W. AMPLISONIC v8 ROADSTER 30W 4 páginas. Four point-to-point guitar amplifier

Imprimir página
HI Knob
To adjust the high eq.
BOOST Knob
To adjust the mid boost. The more you use BOOST the more it will bypass the LO-MID-HI settings. Turn this knob if you
want to get more British sound or feel that your guitar is not cutting through enough. This knob will have great effect for your
sound.
BRILL Knob
To adjust the high eq before power tubes. With this you can control the sound to be sharp or warm.
BASE Knob
To adjust the power amp feedback. This also affects the low sound volume. In minimum position you get more feedback
and presence and in maximum position there is no feedback. If your guitar sounds too muddy turn this counterclockwise.
You can then use GAS knob to turn level back up and also add some clarity.
GAS Knob
To adjust the master volume. This controls signal to the power tubes. If you want dynamics and headroom turn this to the
max and adjust volume with DRIVE.
HEAT Switch
To turn the machine on. In correct operation keep the RUN switch turned off and warm up power tubes for a minute.
RUN Switch
To switch on the high voltage. You are ready to rock!
INPUT Jack (left side)
To connect your guitar.
Footswitch Jack (right side)
Footswitch connector.

BACK panel

0.5at
230
F T2A
9V

MAINS Input

To connect the mains cable. This connector contains the main fuse: 2.0A and remember to use slow blow fuse.
230/115 VAC Switch
To adjust the voltage. Check your operating country before connecting mains.
Fuse
500mA slow blow anode fuse. This might be blown cause of possible tube breakage.
9V Connector
RCA with center +. 9V buzz free output for effect pedals.
OHM Selector
To adjust the impedance. Switch to correct setting according to combined speaker impedance.
OUT Jacks
To connect your speakers. Remember to connect your speaker before powering the unit. These are parallel
connections so e.g. connecting two 8-ohm cabinets turn this to 4-ohm position.
LINE OUT Jack
Output from the speaker line. This can be used for PA and recording purposes. Output impedance 3.3 Kohm.
8
4
16
OUT
OHM
30w
LINE
SEND
15w
6v6
OUT
EFF.LOOP
PAR
RET
SER
CH
F.SW