1byone 102UK-0002 Manual de instrucciones - Página 4

Navegue en línea o descargue pdf Manual de instrucciones para Accesorios 1byone 102UK-0002. 1byone 102UK-0002 5 páginas.

Imprimir página

5. Installation:

Receiver: The receiver can be mounted on a wall or just put

in a flat place.

To be mounted on a wall:

Select a suitable location for the doorbell, usually close to

your door. Drill holes on the wall. Next push the wall plugs

into the drilled holes and then insert the screws into the

wall plugs. Finally, mount the receiver on the screw.

Push button: Install the push button with double-sided

adhesive or by screws:

a. With double-sided adhesive:

• Select a suitable location for the push button, usually

close to your outside door.

• Stick the push button to the wall using the included

double-sided adhesive.

b. By screws:

• Select a suitable location for the doorbell, usually close to

your outside door.

• Pierce the two small grooves (A) on the inner side of the

back cover with a pointed object. Drill holes on the wall.

Next push the wall plugs into the drilled holes and screw

the back cover onto the wall with screws.

• Put the front cover onto the back cover and tighten it,

making sure it is securely closed to ensure the

waterproof IP 44 protection.

Notes:

• The push button and receiver can connect with a range

up to 150m/492ft without any obstacles.

• The push button's transmitting frequency is 433MHz and

its range can be affected by metal ,walls, concretes, and

interfering signals from other electronic appliances with

the same frequency including televisions, radios, and

cookers.

• Please do not install the push button and receiver near to

the above mentioned electronic appliances.

• Please test the operating range of the receiver and push

button in your home before installation.

• Do not install the push button and receiver near any

source of naked flames such as lighted candles.

• Do not expose the push button and receiver to direct

sunlight or high temperatures, otherwise overheating

may cause them irreparably damaged.

c. Install the name plate and rain cover for the push button

• Remove the transparent paper from the name plate

position on the push button.

• Then write your name or room number on a small paper

(size:3.4cm/1.3in x 1.4cm/0.5in). Next, put the small paper

into the name plate position and then put back the

transparent paper.

• Install the rain cover onto the push button.

Note:

If you make the name plate by hand, be sure to use a

waterproof pen.