Follett UD300 Series Manual de instrucciones - Página 11

Navegue en línea o descargue pdf Manual de instrucciones para Fabricador de hielo Follett UD300 Series. Follett UD300 Series 17 páginas. U300/ud300 series ice and beverage dispensers
También para Follett UD300 Series: Manual de instalación (12 páginas)

Imprimir página

Service and parts

Before calling for service

1. Check that ice is in the dispenser and that congealed cubes are not causing a jam.

2. Check that circuit breaker and switches are in ON position.

3. Check that drain pan(s) are on securely. If ajar, neither dispenser nor valves will operate.

4. Check that all drains are clear.

For units equipped with Follett compressed nugget icemaker, see Icemaker Operation and Service

Manual for service and troubleshooting information.

If problem persists after following this basic troubleshooting guide, call Follett's

technical service department at (800) 523-9361 or (888) 2-FOLLETT.

Symptom

Ice does not dispense when switch

is actuated.

• Auger motor does not run

• Wheel motor does not run

• Gate does not open

Ice does not dispense.

• Auger motor runs

• Wheel motor runs

• Gate does not open

Ice does not dispense.

• Auger motor does not run

• Wheel motor runs

Ice does not dispense.

• Auger motor runs

• Wheel motor does not run

Warm drinks or soda foaming.

Dispenser troubleshooting guide

Possible cause

1. Power switch faulty or in OFF position;

loose connection.

2. Faulty dispense switch.

3. Faulty transformer/tripped breaker.

4. Faulty fill board.

5. Drain pan ajar.

6. Faulty drain pan safety switch.

1. Loose electrical connection.

2. Linkage problem between solenoid

and gate.

3. Faulty solenoid.

4. Faulty fill board.

1. Loose electrical connection.

2. Faulty auger motor.

3. Faulty run capacitor.

1. Loose electrical connection.

2. Faulty wheel motor.

3. Faulty run capacitor.

1. No ice in storage bin.

2. Water drained out of ice-waterbath.

3. Faulty circulating pump.

4. Faulty bath solenoid.

5. Faulty thermistor.

Solution

1. Turn power switch to ON, check

connections.

2. Replace switch.

3. Replace transformer/reset

breaker.

4. Replace fill board.

5. Check pan and reseat.

6. Replace switch.

1. Check connections.

2. Check linkage.

3. Replace solenoid.

4. Replace fill board.

1. Check connections.

2. Check auger motor.

3. Check run capacitor.

1. Check connections.

2. Check wheel motor.

3. Check capacitor.

1. Fill storage area with ice or

check icemaker operation. Push

reset on board.

2. Check that ice-waterbath drain

tube is in fixed upright position.

Push reset on board.

3. Check pump. Push reset on

board.

4. Replace bath solenoid. Push

reset on board.

5. Replace thermistor.