Follett EU155N Series Manual de instalación, uso y mantenimiento - Página 14

Navegue en línea o descargue pdf Manual de instalación, uso y mantenimiento para Dispensador de agua Follett EU155N Series. Follett EU155N Series 20 páginas. Ice and water dispensers
También para Follett EU155N Series: Manual de instalación y mantenimiento (20 páginas), Manual de instalación, uso y mantenimiento (20 páginas)

Imprimir página

Before calling for service

1. Check that there is ice in dispenser and that congealed cubes are not causing a jam.

2. Check that circuit breaker and switches are in "ON" position.

3. Check that drain pan, rear lid and top are on securely. If ajar, dispenser will not operate. When the top is off,

auger does not operate, even though the solenoids do.

4. Check that all drains are clear.

Note: For units equipped with Follett compressed nugget ice machine, see Ice machine Operation and Service

Manual for service and troubleshooting information.

Dispenser troubleshooting guide

Sympton

Ice does not dispense.

• Auger motor does not run

• Wheel motor does not run

Ice does not dispense.

• Auger motor runs

• Wheel motor runs

• Gate does not open

Ice does not dispense.

• Auger motor does not run

• Wheel motor runs

Ice does not dispense.

• Auger motor runs

• Wheel motor does not run

No ice in dispenser.

If problems persist after following this basic troubleshooting guide, call Follett's technical service department at

+1 (610) 252-7301.

Possible cause

1. Power switch faulty or in OFF position;

loose connection.

2. Faulty dispense switch.

3. Faulty transformer.

4. Drain pan ajar.

5. Faulty drain pan safety switch.

1. Loose electrical connection.

2. Linkage problem between solenoid and

gate.

3. Faulty solenoid.

1. Loose electrical connection.

2. Faulty auger motor.

3. Faulty run capacitor.

1. Loose electrical connection.

2. Faulty wheel motor.

3. Faulty run capacitor.

1. Power switch in OFF position or faulty.

2. Bin signal switches in OFF position or

faulty.

3. Faulty bin t-stat.

4. Faulty transformer.

5. Ice machine related problem.

6. Faulty run capacitor.

Solution

1. Turn power switch to ON position;

check connections.

2. Replace switch.

3. Replace transformer.

4. Check pan and reseat.

5. Replace switch.

1. Check connections.

2. Check linkage.

3. Replace solenoid.

1. Check connections.

2. Check auger motor.

3. Check run capacitor.

1. Check connections.

2. Check wheel motor.

3. Check capacitor.

1. Check switch and replace if

necessary.

2. Check switch and replace if

necessary.

3. Replace bin t-stat.

4. Replace transformer.

5. Refer to ice machine Operation and

Service Manual for diagnosing.

6. Check for power and bin signal on

ice machine PC board.

EU155N Ice and Water Dispensers