Comco WS6000 Series Manual de instrucciones de uso y mantenimiento - Página 4
Navegue en línea o descargue pdf Manual de instrucciones de uso y mantenimiento para Escritorio Comco WS6000 Series. Comco WS6000 Series 6 páginas. Micro-abrasive blasting workstations
Imprimir páginaMicro-Abrasive Blasting Workstations
4. Using a 4" diameter flexible duct and 2 hose clamps (usually provided with the dust
collector), connect the workstation to a dust collection unit.
5. Follow the instructions in your micro-abrasive blaster manual to prepare for blasting.
CAUTION: The air that comes out of the nozzle contains abrasive. Do
not point the nozzle at anything that could be harmed or damaged as a
result of abrasive flow.
6. With the Power switch on the rear of the workstation turned to OFF, connect the
power cord to the AC voltage outlet.
7. Turn the Power switch to the ON position. The lamps in the workstation should light.
Operation
1. Micro-abrasive blasting operations should be conducted according to the instructions
in the blaster's operation manual.
CAUTION: Never point the nozzle in the direction of the glass window.
The abrasive stream will etch the glass, reducing operator visibility and
requiring premature replacement of the workstation window.
2. Turn the Power OFF when the workstation is not in use.
Common Problems, Causes and Solutions
Light won't illuminate
Fluorescent lamps burned out
Powder build-up in lamp bracket,
preventing electrical contact
Ballast failed
Switch failed
Dust builds up inside
Comco Inc.
1. Remove old lamps
2. Replace lamps (commercial items)
1. Unplug unit
2. Remove lamps
3. Use brush to clean out bracket
4. Reinstall lamps
5. Plug in unit and test
1. Remove lamps
2. Turn Power switch to ON
3. Using voltmeter, test for voltage
across lamp bracket terminals
CAUTION: Practice electrical safety to
prevent shock.
1. Unplug unit
2. Remove back panel
3. Using ohmmeter, test for continuity
across switch terminals with the switch
set to ON.
Service dust collector
Page 4
Issue Date: July 2016