Ampro P/N 5001795A REV A Manual del usuario - Página 15

Navegue en línea o descargue pdf Manual del usuario para Hardware informático Ampro P/N 5001795A REV A. Ampro P/N 5001795A REV A 20 páginas.

Imprimir página
Chapter 2

Replacing the ReadyPanel Memory

The ReadyPanel has one SODIMM slot labeled DIMM1 on the under surface of the
ReadyBoard. The ReadyPanel supports a range of SODIMMs depending on the ReadyBoard it
contains. For memory specifications, refer to the specific ReadyBoard Reference Manual.
CAUTION
To Remove the SODIMM from the ReadyPanel (See
1.
Make sure the ReadyPanel has been shut down and disconnected from the power source.
2.
Remove the ReadyPanel cover as decribed in
3.
Remove the two chassis mounting screws located below the I/O panel.
4.
Disconnect the touch screen flex cable from the touch screen controller card and feed it out of the cable
slot at the bottom of the chassis.
5.
Disconnect the display power cable from the display inverter.
6.
Lift the chassis assembly from the enclosure.
ReadyPanel
To prevent damage to the SODIMM, use good anti-static principles while
performing these procedures.
User's Guide
Figure 2-2
and
Figure
"Opening the ReadyPanel Enclosure" on page
ReadyPanel Components
2-3)
9.
11