Amprobe 34XR-A Manual del usuario - Página 5
Navegue en línea o descargue pdf Manual del usuario para Multímetro Amprobe 34XR-A. Amprobe 34XR-A 19 páginas. Professional digital multimeter
Introduction
The 34XR-A is a True rms autoranging handheld digital multimeter for measuring
or testing the following:
• DC and AC voltage
• Temperature
• DC and AC current
• Capacitance
• Resistance
• Diodes
• Frequency
• Continuity
• Dutycycle
Additional features include: MIN MAX, HOLD, Backlight, and Range Lock
Making Measurements
Verify Instrument Operation
Before attempting to make a measurement, verify that the instrument is operational
and the battery is good. If the instrument is not operational, have it repaired before
attempting to make a measurement.
Range Selection
In addition to autoranging the 34XR-A allows you to manually select and lock a
range by pressing the RANGE button. RANGE appears on the display to indicate
that manual ranging is active. Each subsequent press of the range button steps the
meter to the next higher range. When the highest range is reached the next press
returns the meter to the lowest range. To return to autoranging press and hold the
RANGE button for 2 seconds. RANGE no longer shows on the display.
Use autorange for all initial measurements. Then, when appropriate, use the RANGE
button to select and lock a range.
Warning
To avoid electrical shock while manual ranging use the display
annunciators to identify the actual range selected.
Correcting an Overload (oor -o ) Indication W
An o indication may appear on the display to indicate that an overload condition
exists. For voltage and current measurements, an overload should be immediately
corrected by selecting a higher range. If the highest range setting does not
eliminate the overload, interrupt the measurement until the problem is identified
and eliminated. The o indication is normal for some functions; for example,
resistance, continuity, and diode test.
Measuring DC Voltage
v
1. Set the Function Switch to
.
2. If RANGE is displayed, press the RANGE button to enable autoranging.
3. Connect the Test Leads: Red to E, Black to COM
4. Connect the Test Probes to the circuit test points.
5. Read the display, and, if necessary, correct any overload (o) conditions.
3
See Figure
-1-