Advanced Approach Q248 Instrucciones - Página 2

Navegue en línea o descargue pdf Instrucciones para Electrodomésticos de cocina Advanced Approach Q248. Advanced Approach Q248 4 páginas.

INSTRUCTIONS -- ELECTRIC SLICER

BETRIEBSANLEITUNG -- ELEKTRISCHE AUFSCHNITTMASCHINE

Model Q228/Q268/Q268e/Q269/Q269e series

Page 2 of 4

Check that the switch is turned OFF before inserting the plug into the socket. Adjust

the slice thickness as desired by turning the handle to the appropriate position.

Place the food on the carriage and turn the slicer ON. For best performance, move

the carriage backwards and forwards smoothly and do not press the meat too hard

against the blade.

The duration of your forwards/cutting stroke should be 2-3 seconds. The duration of

your backwards stroke should be at least as long as the duration of your

forwards/cutting stroke, and in any case at least three full seconds or longer.

This appliance must be used with the sliding feed table and the piece holder in

position unless this is not possible due to the size or shape of the food.

Turn the unit off and disconnect it from the power supply when you leave the unit

unattended before attaching or removing accessories, and before cleaning.

This appliance conforms with the Ministerial Decree 10/04/1984 (EEC Directive

82/499) concerning the elimination of radio disturbances.

When using the slicer, always hold the food against the sliding carriage. Use the

food press to hold the food against the blade, unless this is not possible due to the

size or shape of the food.

This electric slicer has been designed to operate for short periods (max 10 min.)

Switch off the appliance before changing accessories or approaching parts that

move in use.

Please be extra careful when handling the sharp cutting blades, and during cleaning.

If the mains cord is damaged, it must be replaced by the manufacturer or its service

agent or a similarly qualified person in order to avoid hazards.

Cleaning

Always unplug the slicer and turn the slice-thickness handle to the zero position

before cleaning. NEVER IMMERSE THE UNIT IN WATER, as this would damage

the electrical components. Surfaces in contact with food should be cleaned with a

slightly damp, lint free cloth.

The carriage may be removed for cleaning. With the blade facing toward you, there

is a low tab protruding up on the right side edge of the chassis. Using a regular metal

table spoon, hold the tab down, and slide the carriage to the right, over the tab. For

re-assembly, again use a spoon to hold the tab down while replacing the carriage

into the slot.

Cleaning the Blade

Caution: the blade is extremely sharp – please take proper care, otherwise