FOLLO FUTURA FOLLO STABILIS Manual - Página 7

Navegue en línea o descargue pdf Manual para Gimnasios FOLLO FUTURA FOLLO STABILIS. FOLLO FUTURA FOLLO STABILIS 13 páginas.

Imprimir página

Thank you for choosing a Follo Stabilis product. We have prepared this instruction manual to enable

you to get the best results from the product. Please read these instructions carefully before assembling

and using the trainer.

Contents:

- Purpose

- Unpacking

- Maintenance

- Extra equipment

- Recycling

THE PURPOSE OF THE TRAINING:

The Arm Trainer is designed to improve circulation. It can be used standing on the floor (as shown in

the illustration on the cover) while the patient sits on a chair/wheelchair, which has been placed on the

floor plates (to keep the machine steady and in position during use). Select a resistance that the

patient can keep up for at least 15 minutes. Rotate using even movements. Movements should be

extended as far as possilble. Read off time and distance on the counter.

SAFETY INFORMATION:

•

Make sure that nothing can be pinched or jammed and that the handles rotate easily and are

properly secured.

•

Always test the machine's functions yourself and allow the patient to test all functions under

supervision before handing out the product for self-training.

UNPACKING:

•

Take care when removing the

machine from its packaging. Do

NOT use a knife or other sharp

instrument as this may damage

the machine. Inspect the machine

for any transport damage.

•

Place the machine on the floor as

shown in the drawing. Stand on

the floor plates A) and press in

the lever (B) to release the gas-

assisted spring. The gas-assisted

spring will now push the machine

upwards at low pressure. See

also item 5 GUIDELINES FOR

USE.

GUIDELINES FOR USE:

Use:  The Manuped is designed for use standing on the floor while the user sits on a

chair/wheelchair placed on the floor plates. Make sure that the chair is pushed well onto the floor

plates.

- Safety information

- Guidelines for use

- Troubleshooting

- Technical specifications

- Spare parts list

Adjusting resistance:  Adjust resistance using the

levers (1). Rotating the levers in a clockwise direction

increases reistance, and loosening anti-clockwise

reduces resistance.

Counter:  The counter (5) is a bicycle computer. It registers when training starts, and is

switched on automatically (displaying the last used function). Use the button (6) on the bicylcle

computer to switch between the different functions: Distance, time, speed, clock and auto

(changes regularly between all functions). Holding

down button (6) will clear time and distance (not the

clock). The computer will switch off automatically

when not in use for a period. Read more about the

bicycle computer's functions in the separate

instructions for use.

Adjusting the length of handles:  The crank throw of the

handles may be adjusted by first loosening the knob (2).

Pull out the lockpin (3) and push or pull the handle to the

required position. Make sure that the lockpin (3) lines up

with a hole and replace the lockpin. Tighten the knob (2).

08/08/18

Side 7

Rev: 10