DPCAV Oracle Manual del usuario - Página 6

Navegue en línea o descargue pdf Manual del usuario para Controlador DPCAV Oracle. DPCAV Oracle 11 páginas. Video diversity controller

Step 6:

The video switching criteria can be altered to suit your preference. When set to

, the video will switch less often (more video noise is tolerated). When set to

, the video will switch more often (less video noise is tolerated). For most

IGH

users the N

,, ,,

Step 7:

The Video Balance Adjustment step is used to ensure that the wireless receivers' video

levels are closely matched for best image quality. This adjustment should be made

whenever new A/V sources are installed. The balance feature requires that the brightest

A/V source is connected to the V

Note: The balance adjustment is found on the bottom of the unit. A small

screwdriver is required to adjust it.

During the balance adjustment mode, the green V

back and forth. At the same time, the two video inputs will also toggle; what you will see

is the video from the two receivers in a ping-pong fashion. The goal is to adjust their

brightness so that the two video sources look the same (or nearly so).

While watching the video image, carefully adjust the balance trimmer found near the

Video Out jack (see photo on the right). The best adjustment is found when the displayed

video image has the least amount of perceived brightness "flicker." When the

adjustment is complete, press the pushbutton switch for at least two seconds to exit.

If the balance trimmer does not provide sufficient range, then it will be necessary to

switch the A/V-1 and A/V-2 input cable positions. This will ensure that the A/V source,

with the highest brightness, is installed on the V

operation of the balancing feature. Don't forget to switch the audio inputs to match the

relocated video cables.

Note: If the battery voltage is too low the Video Balance feature will be disabled. Please

check for a low battery alert if you are unable to enable this feature.

Switching Sensitivity

Range: 1=Very Low, 2=Low, 3=Normal, 4=High, 5=Very High.

setting is best.

ORMAL

Range: 1=On, 2=Skip (exit)

2 input.

1 and V

2 input. This is needed to allow proper

AGE

2 LED's will rapidly toggle

Jan-2008