DPCAV ShutterBug Pro Manual de instrucciones - Página 7

Navegue en línea o descargue pdf Manual de instrucciones para Controlador DPCAV ShutterBug Pro. DPCAV ShutterBug Pro 16 páginas. Digital camera controller

Imprimir página

PROGRAMMING INSTRUCTIONS

"Programming" ShutterBug Pro involves pressing the push

button switch while observing the red and yellow lights. If you

are installing a servo then you will also need a servo signal

source (such as a R/C radio system or servo signal

simulator) to program the servo position settings.

Each programming step involves a blinking Yellow LED. The

blink pattern indicates the programming step that you are on.

There are ten steps, so there are ten unique LED patterns

that will be seen by the time programming is complete.

At each step you will respond by pressing the push switch. The number of presses will program

the feature. For example, during the "Shutter Repeat Interval" programming step, pressing the

switch four times will set the shutter repeat time to four seconds. Once you are done with the

step, just wait three seconds for the Red LED to wink once. ShutterBug Pro will then move to

the next step. If desired, programming can be exited by removing power after the Red LED

winks, which will leave the remaining values unchanged.

If your entry is illegal, the Red LED will rapidly flash for several seconds as a warning. You will

then be allowed to try again. During steps one through seven, if you do not enter your value

within seven seconds, ShutterBug Pro will move to the next step. This allows you to skip the

steps you do not want to change.

The LED patterns are arranged as simple patterns of short and long blinks. The following table

outlines the blink codes (

STEP

= short blink,

RED LED

YEL LED

Off

= long blink,

DESCRIPTION

Camera Wake-up/Standalone Interval

Wake-up/Standalone Interval Units

Shutter Repeat Interval

Shutter Dwell Time

Shutter Repeat / Hold Mode

Focus Dwell Time

External Trigger Mode

Servo Neutral (Home) Position

Servo Stage 1 (Focus) Position

Servo Stage 2 (Snapshot) Position

Page 7

Figure 12, Push Button Switch

= Red LED On).

Sep-15-2013