carbonit QUADRO Manual - Página 2

Navegue en línea o descargue pdf Manual para Sistemas de filtración de agua carbonit QUADRO. carbonit QUADRO 2 páginas. Premium drinking water filter

Imprimir página

PRIOR TO INSTALLATION

Fresh spring water for your home - that's no problem with the

QUADRO made by CARBONIT . In no time, a healthy thirst quencher

flows from your tap. Installation work may only be carried out by a

suitably trained specialist. The filter unit may only be installed after the

water meter and the backflow preventer. The device must be provided

with an earthing bridge.

AVAILABLE VERSIONS OF THE QUADRO

· QUADRO 60 Water inlet right or left, suitable ﬁlter cardridges

4 pieces WFP 10"

· QUADRO 120

Water inlet right or left, suitable ﬁlter cardridges

4 pieces WFP 20"

Scope of delivery

(presentation corresponds to

QUADRO 60 version)

cartridges lifter

wall holder

stopcock

Before connecting the Quadro to the water supply system:

turn oﬀ the cold water supply (angle valve) and tighten and

secure all connections of the pre-assembled components!

INSTALLATION DES FILTERS

Check delivery for completeness (see scope of delivery)

device key

housing cover

sealing disk

cartridges spacer ring

ﬁlter housing

test water outlet

After the installation, starting operations and changing ﬁlters one

should without fail undertake a leakage check and repeat this at least

once after 30 minutes. Only operate with cold water!

Fasten the wall holder to the wall using

suitable fastening material (plugs, screws).

When fastening the wall holder,

please note that a space of approx.

260 mm (QUADRO 60) or 460 mm

(QUADRO 120) above and below the

device is required for filter replacement.

The stopcocks and the test water

outlet must be mounted with suitable

sealing material. Now place the filter unit

on the bolts of the wall holder and fix it

with the Allen key.

Connect the stopcocks to the water

pipe. IMPORTANT: Observe the flow

direction of the water.

Installation of the filter cartridges that

must to be chosen separately:

Open the housing cover using the

device key.

Equip the filter cartridges with the

spacer rings in the upper third section.

Insert the filter cartridges with spacers

into the four stainless steel tubes - make

sure that the inner pressure springs are

seated correctly - and close the device

with the housing covers using the device

key. Make sure that the sealing disks are

correctly placed.

Slowly open the stopcock on the water

inlet side and check the unit for leaks.

Open the ball valve at the test water

outlet and drain off approx. 10-20 liters of

water. The filter unit is rinsed, while some

black coal dust is rinsed out. Flushing

the system is also required when

changing the filter.

By opening the stopcock on the

water outlet side, the home supply

is put into operation. The water

outlet side is marked by a label. In

order to remove already existing

contaminations from the piping

system, the water should flow for

approx. 2-3 minutes from each tap

in the house after the QUADRO

installation has been completed. It

is advantageous to clean all the

aerators in the house in order to

wash out the coarsest dirt.

Leak test!

Check all connections and the filter unit for leaks after completion of

the installation and after approx. 30 minutes.

Your drinking water filter is now ready for use!

FILTER CARTRIDGE EXCHANGE

Close both stopcocks to

disconnect the system from the

water supply.

Open the test water outlet on the

front of the device and let the water

drain out.

Now open the housing cover by

turning it counterclockwise with the

device key. Water might still drain

off from the down facing filter

elements.

Remove the old filter elements. If

necessary, use the cartridge lifter if

the cartridges are too tight. The

cartridge spacer ring must be

removed and slid onto the new filter

elements.

Old filter elements can be

disposed of with household waste.

Continue with points

By opening the stopcock on the

water outlet side, the home supply

is put into operation.

The QUADRO can be used again!

and

4. c