Fomei Digitalis 600 Manual del usuario - Página 6
Navegue en línea o descargue pdf Manual del usuario para Flash de la cámara Fomei Digitalis 600. Fomei Digitalis 600 8 páginas.
Imprimir página8. Troubleshooting
PROBLEM
Light-sensitive diode is not
functioning
Synchro cable is not working
The device is not working
Other
The manufacturer reserves the right to change the specification of the product, without previous notice
whatsoever.
9. Technical information
Model
Manufacturer
Input voltage
Modelling lamp
Flash lamp fuse
Modelling lamp fuse
Safety distance from flash
POSSIBLE CAUSE
Diode is turned off.
The infrared light cannot reach
the IR sensor.
Too much ambient light is
interfering with the reception
sensor.
The inside of the synchro
connector is dirty or dusty.
Shortcut in the synchro cable
or bad connection.
Incorrect input voltage.
Contact the nearest authorized dealer or retailer. Have the
equipment checked by an authorized dealer or retailer. This will
ensure correct function of the product and continuatien warranty
validity.
Digitalis
Fomei a.s.
AC 220-240V-50 Hz
Max. 100 W
250 V T5AL
250 V T10AL
Min. 1m
6
REMEDY
Check, whether or not the CELL
button is turned on.
Change the position of the
infrared light, so it can reach
the sensor.
Move the equipment to a darker
environment.
Clean the connector.
Change the cable (Press the
test button to check if the flash
is working properly).
- Check the connection of the AC
input cord.
- Make sure all connectors are
hooked up properly.
- Check the fuse.