Amptone Lab MIDI Strip Manual del usuario - Página 2
Navegue en línea o descargue pdf Manual del usuario para Controlador Amptone Lab MIDI Strip. Amptone Lab MIDI Strip 4 páginas. Midi controller kit for electric guitar
Imprimir páginaINSTALLATION
MIDI Strip is intended to be installed by professional luthiers and guitar repair/custom shops only. It requires significant
woodworking, as well as having appropriate tools and being able to use them in a safe manner. AmpTone Lab cannot be
held responsible for any damages that may occur during installation.
MAIN CAVITIES
MIDI Strip comes in a form of an easy to assemble kit which needs to
be installed inside an electric guitar body. After planning where you are
going to place all the components, the best place to start installation is
making a cavity at the back of your guitar. This cavity will hold the MIDI
Strip controller unit. It should be 16 mm deep and its diameter should
be approximately 60 mm. You may prefer to make the rectangular
cavity instead – in this case its dimensions should be approximately
60 x 50 mm. This cavity should placed directly under the strip's connector.
After routing this cavity, you will need to connect it with the touch strip
on the guitar top. To do so, drill a 10 mm hole from your guitar body
top right to this cavity. After that you can place and mount the touch
strip – strip's connector will go through this hole.
CONTROL CAVITY
MIDI Strip comes with additional components, which need to be
connected to the controller unit. These components are hold button,
on-off toggle switch, battery clip, rotary encoder, MIDI connector
and status LED (connecting the LED is not necessary).
The aforementioned components can be installed wherever you feel
comfortable with having them. The best place for most of them is
the control cavity where your guitar pots are located. As far as MIDI
connector goes, the most convenient place for it is right next to your
guitar output jack. After mounting these components, all that is left is
to connect all components to their respective connectors on the MIDI
Strip controller unit.
BACK VIEW
10 mm
60 mm
HOLES DIAMETERS
Component
(1) Rotary encoder
(2) MIDI connector
(4) Pushbutton switch
(5) On-off toggle switch
(6) Resistive strip
(7) Status LED
Hole diameter
6 mm
15 mm
12 mm
5 mm
10 mm
7 mm