Fondis WINEMASTER C18 Manual de instrucciones - Página 8
Navegue en línea o descargue pdf Manual de instrucciones para Aire acondicionado Fondis WINEMASTER C18. Fondis WINEMASTER C18 13 páginas.
Imprimir página
WINEMASTER C18 / C18S(R) USER GUIDE
3. USING THE WINEMASTER AIR-CONDITIONER
The thermostat indicates the temperature in the wine cellar with a precision of 2°C.
A temperature change of the air does not mean the same change of temperature of the liquid due to the thermal capacity
of the liquid.
The temperature is set at 12° C in the factory. During installation the set temperature must be controlled and adjusted as
shown in next paragraph if necessary (paragraph 3.1.2 & 3.2.2 ).
3.1 STARTING UP MODEL WINE C18
3.1.1. CONNECTING THE AIR-CONDITIONER
When you plug it into the electrical socket, the air conditioner starts up immediately.
If the temperature in the cellar is higher than the thermostat
immediately. If the temperature in the cellar corresponds to the setting, only the cellar fan which functions
permanently will start.
3.1.2 SETTING THE TEMPERATURE
The temperature is set on the thermostat as follows:
Press buttons 1 and 2 at the same time until the set temperature is flashing. Use button 1 to increase and
button 2 to decrease the set temperature. When the setting is right, press both buttons at the same time to
validate it.
3.2 STARTING UP MODEL WINE C18S(R) (WITH HEATER)
3.2.1. CONNECTING THE AIR-CONDITIONER
When you plug it into the electrical socket. The fan in the cellar starts up immediately. The compressor may
not come on until 2 minutes later if the temperature of the cellar is higher than the set temperature. If the
temperature of the cellar is the same as the setting on the thermostat, the compressor will not come on.
3.2.2 SETTING THE TEMPERATURE
2
3
4
The thermostat is equipped with a joystick on the right hand side (ref. 1) which can be used to change the setting. To
change the setting, simply press on the symbol 5 for 5 seconds. The display (ref. 5) then displays SET. Press the
symbol 5 once again briefly.
The set temperature is displayed. To increase it, press the up arrow . To reduce it press the down arrow . When The
temperature on the display is correct, confirm by pressing to symbol 5 until it shows again SET.
Diode 2 indicates that the device is defrosting.
Diode 3 indicates that it is in heating mode.
Diode 4 indicates that the compressor is running. When there is no diode lit, the cellar temperature is close to the set
temperature.
After changing a setting, because of a fitting which prevents it from starting up too frequently, the compressor will only
start up after a few minutes.
5
12
5
1
November 2002
setteing,
the compressor starts up
Page 30