Daikin Air Conditioner Manual de instalación - Página 3

Navegue en línea o descargue pdf Manual de instalación para Aire acondicionado Daikin Air Conditioner. Daikin Air Conditioner 9 páginas. Daikin air conditioner
También para Daikin Air Conditioner: Manual de instalación (1 páginas), Manual de instalación (8 páginas), Manual de instalación (17 páginas), Manual de instalación (9 páginas), Manual de instalación (9 páginas), Manual de instalación (4 páginas), Manual de instalación (9 páginas)

Imprimir página
Daikin Air Conditioner Manual de instalación

Indoor Unit Installation Drawings

Front panel
1-15/16" (50mm) or more
from walls (on both sides)
Air filters
C Air-purifying filter with photocatalytic
deodorizing function
Tabs (upper 3 locations)
Tabs (lower 2 locations)
Insert the upper side of the
C
with photocatalytic deodorizing function into the tabs
(upper 3 locations), push the lower side of the filters
up a little and into the tabs (lower 2 locations).
Intelligent-eye Sensor
CAUTION
1) Do not hit or forcefully push the intelligent-eye sensor. This can lead to damage and malfunction.
2) Do not place large objects near the sensor. Also keep heating units or humidifiers outside the
sensor's detection area.
B 3/16" × 1"L
(M4 × 25mm)
1-3/16" (30mm) or more
from ceiling
Opening service lid
Service lid is opening/closing type.
Opening method
1) Remove the service lid screws.
2) Lift the service lid upward.
Air-purifying filter
A Mounting plate
Caulk
pipe hole
gap
with putty.
Intelligent-eye sensor
Service lid
D
Wireless remote
controller
1/8" × 13/16"L
F
(M3 × 20mm)
The mounting plate should
be installed on a wall can
support the weight of the
indoor unit.
Cut thermal insulation
pipe to an appropriate
length and wrap it with
tape, making sure that
no gap is left in the
insulation pipe's cut line.
Wrap the insulation pipe with
the finishing tape from bottom
to top.
Before screwing the remote
controller holder to the
wall, make sure that control
signals are properly
received by indoor unit.
E
Remote
controller holder