DR 41416 Manual de seguridad e instrucciones de uso - Página 5

Navegue en línea o descargue pdf Manual de seguridad e instrucciones de uso para Recortadora DR 41416. DR 41416 20 páginas.

Preparing to Use Your HEDGE TRIMMER
Read, understand, and follow all instructions on the HEDGE TRIMMER and in this manual. Be thoroughly familiar with the
control and the proper use of the HEDGE TRIMMER before starting.
Thoroughly inspect the area where you will be using the Trimmer, and remove all wire, sticks, and any other foreign objects
which could become entangled in the Trimmer Blades.
Operating Your HEDGE TRIMMER Safely
Do not use your DR
®
made specifically for the HEDGE TRIMMER.
Avoid unintentional starting - do not carry the HEDGE TRIMMER with your finger on the ON/OFF Switch.
Remove the Battery Pack when inspecting, cleaning, clearing any material from the HEDGE TRIMMER Air Inlet.
Do not operate the HEDGE TRIMMER in gaseous or explosive atmospheres. The Motor normally sparks, and the sparks
might ignite fumes.
Never operate the HEDGE TRIMMER in the rain or wet conditions.
Never over reach and keep proper footing and balance at all times.
Operate only in daylight or in an area well-lit by artificial light.
Watch out for traffic when operating near roadways.
Stay alert and watch what you are doing. Do not operate the HEDGE TRIMMER when you are tired or under the influence of
medication, drugs, or alcohol.
If the HEDGE TRIMMER vibrates abnormally, stop the Motor, remove the Battery Pack, and inspect the tool for any damage.
Check for alignment of moving parts, binding of moving parts, breakage of parts, mounting and any other condition that may
affect its operation. Repair the damage before restarting and operating the HEDGE TRIMMER. NOTE: Excessive vibration is
generally a sign of trouble.
Do not operate the HEDGE TRIMMER if it does not start normally or stop normally with the ON/OFF Switch.
Handling the Battery Pack Safely
Always charge the Battery Pack indoors, never charge it the rain or in wet conditions.
Use only the DR
®
62V Charger with DR
manufacturers or other DR
Never attempt to alter or open the Battery Pack or Charger. There are no customer serviceable parts inside.
Use normal household voltage (110 volts) when charging the Battery Pack. Plug the Charger Power Supply directly into the
electrical outlet.
Exercise care in handling the Battery Pack in order not to short-circuit it with conducting materials such as rings, bracelets,
and keys. When short-circuited, the Battery Pack or conductor may overheat and cause burns.
Electrolyte leakage from the Battery Pack can be harmful causing serious chemical burns if on the skin or in the eyes. Remove
contaminated clothing and wash skin with soap and water. If electrolyte gets in your eyes, flush with cold water for at least 15
minutes and seek medical attention.
Inhalation of vapors from a ruptured Battery Pack can cause respiratory irritation. In case of Inhalation of fumes get fresh air
and seek medical attention.
RO-62V HEDGE TRIMMER for any job other than the intended use. Never try to use an attachment not
®
62V Battery Packs. Do not use the DR
®
products. Use of a different Charger may cause a fire or explosion.
®
62V Charger with Battery Packs from other
CONTACT US AT www.DRpower.com
5