Comelit 1622 Manual técnico - Página 2

Navegue en línea o descargue pdf Manual técnico para Equipos de grabación Comelit 1622. Comelit 1622 20 páginas. Button interface
También para Comelit 1622: Manual técnico (20 páginas), Manual técnico (20 páginas), Instrucciones técnicas (14 páginas), Manual técnico (8 páginas), Manual técnico (6 páginas)

• Install the equipment by carefully following the instructions given by the manufacturer and in compliance with the

standards in force. Do not tamper with the internal elements offering protection against short circuits and overcurrents.

• All the equipment must only be used for the purpose it was designed for. Comelit Group S.p.A. declines any

responsibility for improper use of the apparatus, for any alterations made by others for any reason or for the use of

non-original accessories or materials.

• All the products comply with the requirements of the 2014/30/EU and 2014/35/EU directives. This is proved by the

CE mark on the products themselves.

• Do not route the riser wires in proximity to power supply cables (230/400V).

• Installation, mounting and assistance procedures for electrical devices must only be performed by specialised

electricians.

• Disconnect the power supply before carrying out any maintenance procedures.

• Connect the module support frame to earth (see Fig.)

Warning ............................................................................................ 2

Description ....................................................................................... 3

Installation information ................................................................... 4

Installation with Ikall external unit ................................................. 5

Vandalcom (A) ...........................................................................................6

Roma (B) ...................................................................................................6

Button programming ....................................................................... 7

Dip switch programming table ....................................................... 8

EXAMPLE: dip switch setting for code 200 ...........................................9

Special programming .................................................................... 10

Special programming table ...................................................................11

Operating distances with Art. 1595 .............................................. 13

Operating distances ...............................................................................13

Maximum system expansion .................................................................13

Wiring diagrams............................................................................. 14

voltage check with system in standby. ................................................14

Wiring diagram with safety lock ...........................................................16

Door open indication use variant..........................................................17

Table of contents