AMS Controls XL200 Series Especificaciones - Página 2

Navegue en línea o descargue pdf Especificaciones para Controlador AMS Controls XL200 Series. AMS Controls XL200 Series 8 páginas. Bar code scanner specifications
También para AMS Controls XL200 Series: Manual de sustitución de pilas (5 páginas), Manual de sustitución de pilas (8 páginas), Manual de sustitución de pilas (8 páginas)

Note: Make sure the scanner is configured so that it does not pull pin 7 low. If the scanner pulls pin 7 low

for any reason, the controller will not configure itself for a scanner. The input is retested on every

power up.

Note: The scanner should be setup so that its ground matches the AMS ground, and its TX goes to the

AMS RX. No other connections are necessary for scanner communication.

Zebra LI3608 Bar Code Scanner Setup

Note: The following setup procedure works only with the Zebra LI3608 bar code scanner. For other bar

code scanners, please contact the manufacturer for proper setup procedures.

When a Zebra LI3608 bar code scanner is connected to an XL200 series controller for the first time, the

scanner must be setup to properly communicate with the controller before it can be used for data entry.

Setup Procedure

1. Turn on the scanner. The scanner plays a musical tone, indicating it is on.

2. Verify that the Power Light on the Power Supply is on.

3. Turn off the XL200 series controller, but leave the scanner turned on.

4. Scan the bar code below. Do not proceed to the next bar code until you hear a beep confirming

the scanner has read the bar code.

5. Once the bar codes are read, the setup is complete and the scanner is ready for operation.

6. Turn the XL200 Series Controller on.

NOTE: This particular scanner does not have the capability of turning off the "RTS/CTS" (pin 7 and

Pin 8) signal as described on page 1 of this document, therefore, pin 7 and Pin 8 of the DB9

Connector MUST be clipped or removed for proper operation of the scanner. See the

troubleshooting section for more details.