AMSEC ESLAudit Manual de instrucciones - Página 7

Navegue en línea o descargue pdf Manual de instrucciones para Cerraduras AMSEC ESLAudit. AMSEC ESLAudit 15 páginas. Access control system
También para AMSEC ESLAudit: Referencia rápida (4 páginas)

Imprimir página
AMSEC ESLAudit Manual de instrucciones
3. Insert the USB flash drive into the USB connector on the bottom of the controller.
4. Press the "OK" softkey located beneath the display on the right-hand side.
5. After the download is complete, remove the USB flash drive.
6. Audits can be downloaded onto a PC with the use of "ESLDat" software.
Controller Settings
Backing Up Controller Settings
If you are an ESLAudit lock administrator, it is recommended that you back up the
settings of each lock you are responsible for managing. Each time you change a setting
on the lock, you will be asked to do a backup by inserting a USB Flashdrive into the USB
connector. If you are managing multiple locations, each location should use a unique
Flashdrive to avoid over-writing data from other systems.
1. Login.
2. Press "4" (USB).
3. Press "1" (Save System).
4. Insert USB flash drive.
5. Press the "OK" softkey.
Restoring Controller Settings from a Backup File
Caution: Restoring the system configuration from the USB Flashdrive will over-write all
current system settings. If you have made any changes to the configuration or users at
the Controller without saving them, then the backup you are loading will cause those
changes to be lost. You should always back up the system after any change, and use that
Backup as the base for alterations with ESLConfig and restoration.
1. Login
2. Press "4" (USB).
3. Press "2" (Load System).
4. Insert USB flash drive.
5. Press the "OK" softkey.
6. Press the "OK" softkey.
Change PIN
1. Login
2. Press "3" (Admin).
3. Press "1" (PIN chg).
4. Enter new PIN.
5. Press the "OK" softkey.
6. Enter new PIN again.
7. Press the "OK" softkey.
6