AMSEC DL6000 Manual
Navegue en línea o descargue pdf Manual para Cajas fuertes AMSEC DL6000. AMSEC DL6000 3 páginas.
Imprimir página
Each AMSEC safe is professionally hand-crafted with quality materials and is equipped with a precision-quality, digital
lock. To become familiar with the lock, operate the lock (as outlined below) several times before closing the door and
locking the safe.
OPERATION INSTRUCTIONS:
•
Don't slam the door. Extreme shock can damage the lock or jam the boltwork.
•
Don't shut the door with the boltwork in the locked position. Damage to the boltwork and marring the safe's
finish may result.
•
Don't stack contents of the safe so that the door must be forced shut. Jamming of the boltwork may result.
•
Don't store the combination card inside the safe.
•
Don't use oil, grease or any other lubricant on the digital lock.
•
Keep all moving parts clean and free from obstruction, water and grease.
•
If you experience a difference in the feel of the operation, inconsistency or difficulty opening or operating the
safe, DO NOT LOCK THE SAFE. Immediately contact the security store from whom you purchased the safe. If this is
not practical, contact the AMSEC service department at 951-685-9680, Ext. 1036.
DL6000 LOCK FEATURES
Low Battery Indicator
Emergency Override
Turn Knob
Key Hole
KEEP THE EXTERNAL BATTERY BOX IN A SAFE PLACE - BUT NOT IN THE SAFE!
INITIAL SETUP
Install four (4) AA batteries into the power override box and plug connector into the jack on the bottom, right-hand edge of the
safe's LCD screen. When connected, you will hear several confirmation tones followed by a 'melody' as the safe initializes, followed
by an 'All Ready' word prompt once this is complete. At this point the LCD display should show:
Battery Indicator, Year/Month/Day, Week and Time.
Press #1234# (personal code) or #123456# (administrator code) to unlock safe (the # key awakens the screen from 'sleep' mode).
Upon entering the code successfully the LCD screen will turn blue and display "OPEN." You will now have 5 seconds to turn Knob
to open safe door before the action times out and relocks. If this happens re-enter either of the above codes, remembering to
turn the knob within 5 seconds.
Before proceeding any further, disconnect breakout box from the front of safe and either remove the batteries from the breakout
box to be used in the battery box on the inside of the safe's door, or, alternatively, use 4 additional AA batteries. Once the
breakout box is disconnected and the new batteries are in place, power-up sequence will be repeated.
SETTING THE DATE
The time, date, etc., can all be set regardless of whether the safe's door is open or closed. The date format for the safe is YEAR/
MONTH/DAY. To set the date, first press * and then press 0 to descend or 8 to ascend. You will have 6 seconds to make an entry
between fields or the operation will be canceled. If this happens press the * key to again enter time/date mode, skipping to the
last field of entry using the #. Once the desired year value is reached, press the # to move to the next field, again using 0 or 8 to
reach the desired month, day and so on.
Time Display
LCD Display
External Battery Plug
EXTERNAL BATTERY BOX
Operating Your Safe
LOCATION OF BATTERY COMPARTMENT AND RESET BUTTON
- IMPORTED RESIDENTIAL FIRE SAFES
LOCATION OF BATTERY COMPARTMENT AND RESET BUTTON
- ELECTRONIC SECURITY SAFES
Keypad
Internal Battery
Reset Button/Combination
Compartment
Reset Button/Combination
Protected by Lift-Off Cap
Internal Battery Compartment