Electrolux # Manual de uso y mantenimiento - Página 15

Imprimir página

Electrolux # Manual de uso y mantenimiento

1. Setting Surface Controls

OPERATING THE TRIPLE SURFACE RADIANT ELEMENT

Both the 30" and 36" cooktops are equipped with "Triple" surface radiant elements

located as shown in Figs. 1 & 2. A touch key pad on the element controls is used

to select one of the 3 positions of the element. Symbols and indicator lights on

the control panel are used to indicate which coil of the triple radiant element will

heat. The symbol indicates that only the inner element (See Fig. 3) will heat.

The

symbol indicates that both inner and middle elements (See Fig. 4) will heat

together. The

will heat. You may switch from either of these settings at any time during cooking.

To Operate the Triple Surface Element:

1. Place correctly sized cookware on the radiant surface element.

2. Touch and hold the

light above the

within 20 seconds the request to Power ON the cooktop will clear.

3. Touch and hold the

a beep is heard. The display will show " -- ".

Note: If no further pads are touched within 10 seconds the request to

power the element ON will clear.

4. Select the INNER (Fig. 3), MIDDLE (Fig. 4) or ALL 3element (Fig. 5) to heat by touching the

key pad.

5. Touch pad once to turn ON the power level to

of the or pad will decrease or increase the power level from

levels between 3.0 and 1.0 will decrease or

ower level available.

y time while the element is ON.

etting and then turn to a lower setting to

s a constant amount of heat at each

xtending beyond the bottom edge of the

ll for the surface heating area.

if no other surface element is used touch the

Note: The HE message will appear in the display after turning the control knob to OFF if the

cooktop is still hot and remain on until the heating surface area has cooled sufficiently.

NOTE

See the Recommended Setting for Surface Elements chart, on page 12, to make the correct setting.

Fig. 4

O O P O O

Setting Surface Controls

symbol indicates that all 3 portions of the element (See Fig. 5)

key pad until a beep sound. The power indicator

POWER

will turn ON. Note: If no other key pad is touched

POWER

pad for the desirede triple element position until

On/Off

HI. Touch pad once for

9.0

Lo.

pad once to turn the element OFF and

On/Off

key pad to turn off the cooktop.

POWER

Fig. 1

Fig. 2

Fig. 3