Electrolux 725239 Manual - Página 29

Navegue en línea o descargue pdf Manual para Frigorífico Electrolux 725239. Electrolux 725239 34 páginas. Vertical refrigerators
También para Electrolux 725239: Manual del usuario (18 páginas)

Imprimir página

E.6

Fitting anti-tipping cables on glass door

models (2 module) with feet or wheels

When installing the appliance, make sure to fix the anti-tipping

cables to it. To fit, proceed as follows:

1. undo the two Phillips screws securing the bracket to the

rear side on the roof of the machine, as shown in the

figure;

2. remove the cables from their packing;

3. join a slot of the cable to the screw;

4. retighten the screw complete with the cable on the roof of

the appliance;

5. the cable must then be fixed to the wall with a plug, to

permanently secure the appliance;

6. Repeat the same operation also with the other cable.

E.7

Plumbing connection

CAUTION

The plumbing connection must be carried

out by a specialised personnel.

The machine has a drain hole for any liquids present in the

compartment. Connect the compartment drain hole "D",

located on the bottom of the appliance and provided with a

closing plug, to a drain. The drain hole diameter is "17.5 mm",

therefore it is advisable to connect it to a "17.5 mm" drain pipe.

E.8

Reversing opening of fully insulated

doors

CAUTION

The user cannot reverse the door opening

direction in all models with glass door.

Models with glass door come with opening

from left to right. To reverse the opening

direction in refrigerated models, call the

Customer Care Service.

Single- door refrigerated cupboards are normally supplied with

right opening. When converting to left opening, proceed as

follows:

• open the control panel, loosening the 2 screws located

between the panel and door;

• undo the 2 fixing screws of bracket "A" and the screw

securing hinge "B" (detail 1);

• remove the door and remove hinge "B" from right to left,

break the precut "F" on the opposite side and insert part "B"

(detail 6) and the bracket as shown in the figure;

• remove the lower bracket "D", refitting it in the special seat

on the opposite side (detail 2);

• position the door on the lower bracket "D";

• position the upper bracket "A" between the door and the

roof of the appliance, tightening the fixing bolts;

• before tightening the screws, align the door with the panel of

the cabinet, adjusting the lower and upper brackets and

making sure the seal is perfectly fitted on all sides;

• then tighten the bracket fixing bolts.