Electrolux 807650601 Manual de uso y mantenimiento - Página 22

Navegue en línea o descargue pdf Manual de uso y mantenimiento para Frigorífico Electrolux 807650601. Electrolux 807650601 39 páginas.

Imprimir página
22 Automatic ice
- Freezer
Ice maker operation & care
(seWect models)
After the refrigerator is installed properly, the ice maker
can produce ice within 24 hours, tt can completely fill an
ice bin in about three days.
When using the ice maker for the first time and in order
for the ice maker to work properly, it is necessary to
clear air from water filter tubing. Once ice maker begins
making ice, allow the bucket to fill completely; then
discard the first TWO FULL buckets of ice. It will take at
least two days to completely fill the bucket on regular
ice making mode or 11/2days on fast ice mode.
The ice maker produces approximately four pounds of
ice every 24 hours depending on usage conditions.
IMPORTANT
"four ice maker is turned on at the factory so it can
work as soon as you install your refrigerator. If you
cannot connect a water supply, lift the ice maker's
wire signal arm to turn it off. Otherwise, the ice
maker's fill valve may make a loud chattering noise
when it attempts to operate without water.
Turning the ice maker on and off
Ice production is controlled by lifting/lowering the ice
maker's wire signal arm. To gain access to the ice
maker, pull the freezer drawer out. Lift the wire signal
arm to turn the ice maker OFF and lower the wire signal
arm to turn it ON.
I ON
nal Arm
Ice maker tips
,, If your refrigerator is not connected to a water
supply or the water supply is turned off, turn off
the ice maker by lifting wire signal arm.
,, The following sounds are normal when the ice
maker is operating:
Motor running
Ice dropping into ice bin
Water valve opening or closing
Running water
,, Ice cubes stored too long may develop an odd
flavor. Empty the ice bin as explained below.
Fast Ice Function
Your refrigerator is equipped with a "Smart" Fast Ice
Function, that will, if activated at your user interface,
allow an increase in ice production. You do not need to
deactivate it, if not needed, your refrigerator wilt operate
on normal conditions.
CAUTION
If the water supply to your refrigerator
is softened,
be sure the softener is properly maintained.
Chemicals
from a water softener can damage the
ice maker.
Cleaning
the ice maker
Clean the ice maker and ice bin at regular intervals,
especially prior to vacation or moving.
I
Turn off the ice maker.
2
Remove the ice bin.
3
Empty and carefully clean the ice bin with mild
detergent. Do not use harsh or abrasive cleaners.
Rinse with clean water.
4
Allow the ice bin to dry completely before
replacing in the freezer.
5
Replace the ice bin.Turn the ice maker on.
Remove and empty the ice bin if:
,, An extended power failure (one hour or longer)
causes ice cubes in the ice bin to melt and freeze
together.
Remove the ice bin and shake to loosen the cubes or
clean as explained above.
CAUTION
NEVER use an ice pick or similar sharp
instrument to break up the ice. This could damage
the ice bin.
To loosen stuck ice, use warm water. Before
replacing
the ice bin, make sure it is completely
dry.