Electrolux 925060333 Procedimientos de diagnóstico - Página 10
Navegue en línea o descargue pdf Procedimientos de diagnóstico para Frigorífico Electrolux 925060333. Electrolux 925060333 14 páginas.
Imprimir página
Displayed
Function
code
Test
78
Ice Maker
Tray Bail
Arm/ Ice
Level Bucket
61
Stepper
Motor Valve
Copyright 2018 ELECTROLUX HOME PRODUCTS PTY LTD Technical Services
Action Available
Press (MODES) to
change the status
of the Function
Press (MODES) to
change the status
of the Function
ARESI1006
Behavior Expected
d. In case of failure at the end of the
twisting action it shows "Er".
e. Press (MODES) button to change the
status and start the rotation.
a. Remove the Ice Bucket in order to
see clearly the status of the ice tray
bail arm..
b. Allow bail arm to drop freely. It shows
"Em" (empty) when tray returns to
"home" position.
c. Hold bail arm up with the hand. It
shows "Fu" (full) when tray returns to
"home" position.
d. During the rotation of the ice tray, it
blinks on the display "1".
e. In case of failure at the end of the
twisting action it shows "Er".
f.
Press (MODES) button to change the
status and start the rotation of the ice
tray.
a. First Position must be ("Open-
Open") and it is turned on
automatically the compressor at
maximum speed.
b. Going through the steps below, the
stepper valve goes to Close position,
then IM/FZ and after this FF/IM/FZ.
It is possible to loop through these 4
states.
c. Indicating in the display the steps as:
i.
"03" – Open position
ii.
"00" – Close position
iii.
"01" – IM/FZ position
iv.
"02" – FF/IM/FZ position
d. During the steps 00 and 01 test
positions the Ice Maker Evaporator
Defrost Sensor temperature is flashed
on the display in order to check the
temperature decreasing or not in the
Ice Maker evaporator.
e. During the steps 03 and 02 the Fresh
Food Evaporator Defrost Sensor
temperature is flashed in order to
check the temperature decreasing or
not in the Fresh Food evaporator.
f.
During the movement of the stepper
motor from one step to another, it
blinks on the display "1".
g. Press (MODES) button to change the
status of stepper motor valve.