Bosch 8 Series Manual del usuario e instrucciones de instalación - Página 19

Unscrew the two lower screws on the back of the

appliance.

Use the two screws to tighten the two metal retain-

ers on the back of the appliance.

Ensure that the metal retainers are aligned ex-

‒

actly with the edge of the appliance.

Slide the appliance into the fitted unit and check

whether the tilt protection engages.

If required, correct the position of the bracket with

the elongated hole.

Finally, screw the brackets to the fitted unit.

Insert the power cable fully into the appliance.

Push the appliance into the fitted unit.

10.

Do not pinch the power cable.

‒

Remove the adhesive strip from the appliance front.

11.

Open the appliance carefully and check whether the

12.

tilt protection is working.

Installing the appliance

WARNING ‒ Risk of injury!

When the door is opened, the appliance may tip over.

In the case of installation without an intermediate

▶

floor, weigh down the appliance with a suitable

weight before opening.

Insert the power cable fully into the appliance.

Push the appliance all the way into the fitted unit.

Do not pinch the power cable.

‒

Centre the appliance.

Remove the adhesive strip from the appliance front.

Open the appliance.

Screw the appliance to the fitted unit.

Insert the power cable into a protective contact

socket.

The power cable must not touch the rear and base

of the appliance after installation.

Installation instructions en