Bosch 8 Series Manual de instrucciones de instalación y uso - Página 8

Imprimir página

Bosch 8 Series Manual de instrucciones de instalación y uso

Cleaning and maintenance

Saturation display

When the metal grease filters or the activated charcoal

filter are/is saturated, an audible signal sounds for

approximately four seconds after the fan is switched off.

The indicator above the corresponding symbol flashes

as well:

Metal grease filter:

■

Activated charcoal filter:

■

If you have not yet done so, the metal grease filters

should now be cleaned or the activated charcoal filter

changed.

For instructions on how to clean the metal grease filters,

please refer to the section:

The saturation indicators can be reset while they are

flashing. To do this, touch the appropriate symbol.

Switching over the indicator for air recirculation

mode

For air recirculation mode, the electronic control

indicator must be switched over accordingly:

The extractor hood must be connected but remain

■

switched off.

If the air recirculation mode starter set is fitted, touch

■

and hold the

and

until the bars above symbols 1 and

CleanAir air recirculation module is fitted, touch and

hold this button combination again until the bars

above 2 and

light up.

Touch and hold this button combination again to

■

switch the electronic control indicator back to air

extraction mode (

Lighting

The lighting can be switched on and off independently

of the fan.

Touch the

symbol.

Setting the brightness

Press and hold the

symbol until the required

brightness is reached.

Audible signal

Switching on the audible signal

Touch and hold the

same time for approximately three seconds when the

fan is switched off. An audible signal sounds as an

acknowledgement.

Switching off the acoustic signal

Repeat the "Switching on the acoustic signal" process.

Cleaning and maintenance

symbols at the same time

light up. If the

indicator).

and

symbols at the

2Cleaning and maintenance

Warning

t e n a n c e

C l e a n i n g a n d m a i n

Risk of burns!

The appliance will become hot during operation,

especially near the bulbs. Allow the appliance to cool

down before cleaning.

Warning

Risk of electric shock!

Penetrating moisture may result in an electric shock.

Clean the appliance using a damp cloth only. Before

cleaning, pull out the mains plug or switch off the circuit

breaker in the fuse box.

Warning

Risk of electric shock!

Do not use any high-pressure cleaners or steam

cleaners, which can result in an electric shock.

Warning

Risk of injury!

Components inside the appliance may have sharp

edges. Wear protective gloves.

Cleaning agents

Observe the information in the table to ensure that the

different surfaces are not damaged by using the wrong

type of cleaning agent. Do not use

harsh or abrasive cleaning agents,

■

cleaning agents with a high concentration of alcohol,

■

hard scouring pads or sponges,

■

high-pressure cleaners or steam cleaners.

■

Wash new sponge cloths thoroughly before use.

Follow all instructions and warnings included with the

cleaning agents.