Bosch 800 Series Manual de instalación - Página 9

Install the Cooktop

Insert the cooktop into the cutout. Attach the clamps of

the mounting brackets packaged with the cooktop. Use

the washer and screws provided.

Adjust the mounting brackets to desired position and

tighten screws to cooktop. Insert adjusting screw into

clamp and secure cooktop to countertop.

Attaching Mounting Brackets

Cooktop

B/H Hold Down Bracket

C/E Adjusting Screw

Foam Tape (Seal)

Wooden Block (to be used with solid surfacing

material)

Note: For solid surface material installations:

Insert a wooden block between the end of the screw

▯

and the bottom of the countertop.

Do not overtighten adjusting screw.

▯

Trim excess aluminum tape around cooktop flange.

▯

Tip: Install hold down bracket without the adjusting

screw installed. Turn hold down brackets flush with the

sides of the cutout. This will help with inserting cooktop in

hard-to-reach spaces.

The gas inlet to the unit is located at the right rear of the

cooktop.

Install the pressure regulator (supplied with unit) to

manifold pipe using Teflon tape on threads of manifold

pipe. Turn to hand tighten plus 1/4 turn, not exceeding 1

turn for alignment. To prevent possible damage to the

gas pressure regulator, install it after the cooktop is in its

permanent position. When the regulator is securely

installed on the manifold pipe, the conversion nut will be

easily accessible.

Pressure Regulator

Manifold Pipe

Conversion Nut

Pressure Regulator

WARNING

Do not attempt any adjustment of the pressure

regulator, except when converting to propane.

Adjustments could lead to leaks or cause incorrect

gas pressure to the appliance.