Bosch DISHWASHER Manual de instrucciones - Página 19

Imprimir página

Bosch DISHWASHER Manual de instrucciones

Washing dishes

Reduce costs!

If only a small number of dishes have

been loaded into the dishwasher, selecting

a programme that operates at the next

lowest temperature will usually suffice.

Programme data

The programme specifications can be

found in the summary of instructions.

Programme specifications refer to normal

conditions. Greater deviations may occur

due to:

different amounts of dishes

temperature of mains water supply

pressure of mains water supply

ambient temperature

fluctuations in mains voltage

machine-related factors (e.g.

temperature, water volume, ...).

Energy and water consumption is reduced

by up to 1/4 when dishes are washed in

the upper basket only.

Water consumption values are based on a

water hardness setting of 4.

Aqua sensor *

* on applicable models

The Aqua sensor is an optical measuring

device which measures the turbidity of the

rinsing water. A light barrier can detect

dissolved food remnants in the water, e.g.

egg, fat and oats.

The Aqua sensor is used according to

the programme. When the Aqua sensor

is active, "clean" rinsing water may be

transferred into the next rinsing bath

and/or the temperature adjusted. If the

turbidity is greater, the water is drained

and is replaced with fresh water. In this

way the water consumption is reduced by

approx. 4 litres for utensils which are "less"

dirty.

Switching the dishwasher ON

Turn on the tap.

Set main switch

Indicators light up according to the last

programme that was selected.

This same programme will run again if

no other programme button

pressed.

The numerical display

expected duration of the programme.

The programme starts automatically.

Remaining running time display

When the appliance has started, the

expected programme running time is

displayed. The programmed running time

is affected by the water temperature, the

number of dishes, as well as the degree

of soiling. If these conditions are changed,

the running time (depending on the

selected programme) can vary greatly.

As the effect is not detected until a

programme is running, the time may

be longer or shorter than expected.

Time delay *

on applicable models

You can delay the start of the programme

in 1-hour steps up to 19 hours.

Switch on the appliance.

Press the timer programming button

until the digital display

Keep pressing the timer programming

button until the required time is

displayed.

To delete the timer programming,

keep pressing the button until

is displayed.

You can change your programme

selection at any time until the

programme starts.

End of programme

The programme has ended when a figure

appears in the numerical display

to ON.

shows the

jumps