Bosch SB Series Manual de instrucciones - Página 23

Imprimir página

6. To delete the preselected starting

time, press the button P until

indicated on the digital display.

You can change your programme

selection at any time until the

programme starts.

End of programme

The programme has ended when the

value :

is indicated on the numerical

display H.

Switching off automatically

after the end of

the programme *

* depending on model

To save energy, the dishwasher is

switched off 1 minute after the

programme ends (factory setting).

Automatic disconnection

can be adjusted from :

Appliance does not switch off

automatically

Off after 1 min

Off after 120 min

1. Close the door.

2. Switch on ON/OFF switch (.

3. Press and hold down the START

button @.

4. Rotate programme selector 8

until : ... s indicated on the digital

display H.

5. Release button.

The factory set value :

the digital display H.

To change the setting:

1. Rotate programme selector 8 until

the required value is indicated on the

digital display H.

2. Press START button @.

The set value is saved.

S w i t c h i n g o f f a u t o m a t i c a l l y a f t e r t h e e n d o f t h e p r o g r a m m e

to :

is lit on

Operating the appliance

Switching off the appliance

Short time after the end of the

programme:

1. Switch off ON/OFF switch (.

2. Turn off the tap (not applicable if

Aqua-Stop fitted).

3. Remove the utensils when they have

cooled down.

Note

When the programme ends, leave

the appliance to cool down a while

before opening it. This will prevent

steam from escaping and causing long-

term damage to your built-in furniture.

Interrupting the programme

1. Switch off ON/OFF switch (.

The LEDs go out. The programme is

saved.

If the door was opened on an

appliance which has a warm water

connection or is heated, first leave

the door ajar for several minutes and

then close. Otherwise, expansion

(pressure) may cause the appliance

door to spring open or water to run

out of the appliance.

2. To continue the programme, switch

on the ON/OFF switch ( again.

T erminating the programme

T e r m i n a t i n g t h e p r o g r a m m e

(Reset)

1. Press START button @ for

approx. 3 sec.

The numerical display H

indicates :

2. The programme sequence lasts

approx. 1 min. On the digital

display H is indicated :

3. Switch off ON/OFF switch (.