Bosch Series 4 Manual de instrucciones - Página 6

Imprimir página

Gas burners

Accessories

The following accessories can be purchased from the

Technical Assistance Service:

--------

Code

HEZ298114 Additional espresso maker grid

NEZ34VLA Fasteners

The manufacturer accepts no liability if these

accessories are not used or are used incorrectly.

Additional espresso maker

grid

Only suitable for use on the

smallest burner. Use cookware

with a diameter of less than

12 cm.

ÄGas burners

S witching on manually

G a s b u r n e r s

Press the control knob for the selected burner and

turn it anticlockwise to the highest power setting.

Hold an igniter or a naked flame (such as a lighter or

a match) against the burner.

Automatic ignition

If the hob has automatic ignition (ignition plugs):

Press the control knob for the selected burner and

turn it anticlockwise to the highest power level.

While the control knob is held down, all the burners

will generate sparks. The flame ignites. Wait a few

seconds.

Release the control knob.

Turn the control knob to the required position.

If the burner does not ignite, switch it off and repeat the

steps described above. This time, hold the control knob

down for longer (up to 10 seconds).

Warning – Risk of deflagration!

If the flame does not ignite after 15 seconds, switch off

the burner and open a window or the door to the room.

Wait at least one minute before switching the burner on

again.

It is important to keep the appliance clean. If the

Note:

ignition plugs are dirty, this may cause ignition

problems. Clean the ignition plugs regularly with a

small, non-metallic brush. Take care to prevent the

ignition plugs from suffering any heavy knocks.

Safety system

Your hob is equipped with a safety system

(thermocouple) that cuts off the gas when the burners

are accidentally switched off.

To ensure that this device is active:

Switch on the burner as usual.

Without releasing the control knob, press and hold it

down firmly for 4 seconds after lighting the flame.

Switching off a burner

Turn the corresponding control knob clockwise to the 0

setting.

A few seconds after the burner is switched off, a sound

(thud) will be produced. This is not a fault - this means

that the safety device is no longer operating.

Warnings

It is normal to hear a soft whistling noise while the

burner is operating.

When first used, it is normal for the burner to give off

odours. This does not pose any risk and does not

indicate a malfunction. They will disappear in time.