Dragon-RC DRS-3 Manual de instrucciones - Página 4

Navegue en línea o descargue pdf Manual de instrucciones para Receptor Dragon-RC DRS-3. Dragon-RC DRS-3 4 páginas.

Transmitter DTS-3 #210013

Receiver

DRS-3 #210014

Turn on the transmitter and receiver. Insert the Bind Connector (included with the radio-

set) to fail safe position on receiver as in the diagram. Red LED-light flashes twice and

becomes solid. Setting is successful. Remove the pin header after setting before use.

www.dragon-rc.com - Accessories for radio controlled cars - Dragon-RC is a registered brandname.

OPERATING PROCEDURE

Before operation:

After operation:

1) Connect the battery

1) Turn of the receiver

2) Turn on the transmitter 2) Turn off the radio

3) Turn on the receiver

3) Disconnect the battery cables

1 Connect the receiver to the power source and then connect

the Bind Connector to the 'pair' pin header on the side of the receiver.

The LED-light on the receiver should start flashing rapidly.

2 Switch on the transmitter, and then pull the Bind Connector

out of the receiver.

3 The LED-light on the receiver should become solid.

Binding of the transmitter and receiver is then successful.

If not then repeat the above steps carefully.

4 Store the Bind Connector carefully for future use.