DRAGONFIRE 16-1806 Manual

Navegue en línea o descargue pdf Manual para Accesorios para automóviles DRAGONFIRE 16-1806. DRAGONFIRE 16-1806 2 páginas. Trailing arm dragonscales fits polaris rzr xp 1000 & polaris rzr rs1

Imprimir página

DragonFire Racing

3191 N Washington St. Suite 2

Chandler, AZ 85225

1 (800) 708-9803

http://www.DragonFireRacing.com

Congratulations on your purchase of the DragonFire Trailing Arm DragonScales Now you can ride in Style, while also protecting

your Trailing Arms. Be sure to check out the full line of DragonFire Accessories for your Polaris vehicle at your local authorized

• Read and understand these instructions before installing product

• This product does not provide roll over protection

• Do not use product if there are any signs of damage

Off road activities can be hazardous and could lead to injury, dismemberment, paralysis and death. No warranty

of representation is made as to the products ability to protect the user from any injury or death. The user assumes

that risk. The acceptance and /or use of this merchandise purchased from DragonFire by the customer hereby

shall release DragonFire from any and all liability pertaining to the use of such merchandise.

Step 1:

Place vehicle on a flat and level surface. Place gear selector in "Park" and remove keys from the ignition.

Step 2:

Lift the rear end of the vehicle with a hydraulic jack until both rear tires are off the ground (Figure A). Place two jack stands under

neath the vehicle (Figure B). View the Vehicle Manual for recommended points to place the jack, and jack stands.

Step 3:

Remove the Sway Bar Bolt using a 15mm Socket, and the Shock Mount Bolt using the 18mm Socket (Figure C). Retain hardware as

it will be re-used in a later step.

Note:

You may have to apply slight upward pressure on the Trailing Arm to get the Shock Mount Bolt out.

Trailing Arm DragonScales

Part # 16-1805

Part # 16-1806

Fits Polaris RZR XP 1000 & Polaris RZR RS1

Trailing Arm Guard Skid Plate Kit 16-1807 Sold Separately

dealer or online at

http://www.DragonFireRacing.com

Disclaimer

DragonFire

Trailing Arm Guard

Black

Silver

Tools Required

Hydraulic Jack

Jack stands

Torque Wrench

Socket Wrench

18 mm Socket

15 mm Socket