Drainvac 2AC9932-CT Manual del usuario - Página 14

Navegue en línea o descargue pdf Manual del usuario para Sistemas de aspiración centralizada Drainvac 2AC9932-CT. Drainvac 2AC9932-CT 15 páginas.
También para Drainvac 2AC9932-CT: Manual del usuario (15 páginas), Manual del usuario (15 páginas)

Imprimir página

WEEE GUIDELINES

This unit complies with the WEEE (Waste Electrical and

Electronic Equipment) Guidelines, which promote the

recycling of this type of waste equipment and encourage the

development of products that are adapted to efficient waste

reclamation at the end of their life cycle.

The WEEE Guidelines stipulate that the original supplier should

agree to reclaim any obsolete equipment free of charge. We

recommend that you advise your supplier that you would like

him to reclaim your unit when you order and replace it with a new one.

Do not discard the unit with your regular garbage. The symbol representing a garbage

bin on wheels on the unit's label (Figure C) attests to this requirement. You must

ensure that, at the end of its life cycle, your unit is reclaimed, treated and recycled by

an authorized retailer or firm.

For more information, contact your municipal waste management department.

RoHS

All presented units respect the European directive RoHS which limits the usage of

six dangerous substances.

SUPPORT

If you wish to speak with a customer service representative, please contact your

supplier/dealer.

To find a retailer near you, please visit our website .

THE UNIT WON'T START UP...

SOLUTION :

1) Check if the LED is lit.

2) Check the circuit breaker in your electrical panel.

3) Check the unit's circuit fuse/breaker.

4) Check the 24-volt circuit, as follows :

Figure C

Establish an electrical contact between the two 24V circuit terminals of the unit with a

metal object such as a screwdriver or a coin.

• If the unit starts up, either the 24V wire is cut or disconnected from one of the

wall inlets, or the hose is defective.

• If the unit does not start up after all theses steps, the printed circuit is defective.

THE UNIT WON'T SHUT DOWN...

SOLUTION :

Check the 24-volt circuit as follows :

Disconnect one of the two wires on the unit's 24-volt circuit.

• If the unit shuts down, the problem could be that two 24-volt wires are touching

themselves somewhere or that the wall inlet is defective.

• If the unit doesn't shut down, the printed circuit is defective.

Unplug the power cord.

150 Brunet Street, Mont-St-Hilaire, QC J3H 0M6, Canada

TECHNICAL PROBLEMS

Drainvac International