DRAKE AUDIOACCENT Manual de instrucciones - Página 8

Navegue en línea o descargue pdf Manual de instrucciones para Receptor DRAKE AUDIOACCENT. DRAKE AUDIOACCENT 16 páginas. Assistive listening system

Imprimir página

Front Panel Controls and Indicators

LEVEL

MONITOR OUTPUT

MONIT OR

1. MONITOR OUTPUT - Connect headphones to listen

to the audio that is supplied to the transmitter. The

monitored level will vary with the level of the incoming

audio, the setting of the INPUT LEVEL control, and the

setting of the MONITOR OUTPUT level control.

2. MONITOR OUTPUT LEVEL Control - With the

INPUT LEVEL control set properly, adjust this control

for a comfortable listening level in the connected

monitor headphones.

3. INPUT LEVEL Control - This control is used to

adjust the input sensitivity. For a monaural audio input

signal, set this control at or just below the point where

the (OVER) MODULATION LED indicators light on

audio peaks. For a stereo input signal, set this control

at or just below the point where either of the (OVER)

MODULATION LED indicators light on audio peaks.

4. (OVER) MODULATION Indicators - In this model,

these indicators light to aid in the setting of the INPUT

LEVEL control for proper modulation. They light to

indicate that full modulation is being reached when the

rear panel LIMITING/COMPRESSION switch (see rear

panel Item 4) is set to "OFF". With the switch set for

either the "L" or "C+L" position, these indicators will

light on audio signal peaks as the limiter is activated at

full modulation. Also see rear panel Item 4 for

additional hints for proper setting of the LIMITING/

COMPRESSION switch for a given type of audio

source. Set the INPUT LEVEL control at or just below

the point where the (OVER) MODULATION indicators

light on audio peaks.

OVER MODULATION

I NPUT

LEFT

R I G H T

ALT 1000 ASSISTIVE LISTENING TRANSMITTER

TUNE

72.1 MHz Stereo

F R E QU EN C Y

5. TUNE

Buttons - Press to set the displayed

operating frequency: 72.1 - 72.9 MHz, in 100 kHz

increments; 74.7MHz; or 75.3 - 75.9 MHz, in 100 kHz

increments. Press and hold both buttons until the

displayed 'Mono' or 'Stereo' flashes. Release both

buttons and press either

'Stereo' or 'Mono' as required. After a short delay, the

displayed 'Stereo' or 'Mono' will stop flashing. With a

steady 'Stereo' or 'Mono' displayed, the TUNE

buttons permit setting the frequency.

6. FREQUENCY/Mode Display - Indicates the

operating frequency and mode, Mono or Stereo, when

the rear panel 'POWER' switch is set to the 'ON'

position and the AC Adapter is connected and powered

from an AC source.

to alternately set