Bosch 2 Manual de instrucciones original - Página 8

OBJ_BUCH-965-004.book Page 17 Thursday, August 6, 2009 2:38 PM

Operation

Initial Operation

Protect the measuring tool against moisture and direct

sun light.

Do not subject the measuring tool to extreme tempera-

tures or variations in temperature. As an example, do not

leave it in vehicles for longer periods. In case of large varia-

tions in temperature, allow the measuring tool to adjust to

the ambient temperature before putting it into operation.

Avoid heavy impact to or falling down of the measuring

tool. Damage to the measuring tool can impair its accuracy.

After heavy impact or falling down, check the angle accura-

cy between the 0° and 90° laser line with the angle of a pre-

cision square.

Switching On and Off

To switch on the measuring tool, briefly press the On/Off

switch 1. Immediately after switching on, the measuring tool

sends out the two laser lines at 0° and 90°.

Do not point the laser beam at persons or animals and do

not look into the laser beam yourself, not even from a

large distance.

To switch off the measuring tool, push the On/Off switch 1

again.

Do not leave the switched on measuring tool unattended

and switch the measuring tool off after use. Other persons

could be blinded by the laser beam.

Always place the measuring tool level on the floor or fas-

ten it plane against the wall. When placing down or fasten-

ing unevenly, the angle will not be precisely 90°.

When laying floor tiles, do not use spirit levels 3 and 5 for

levelling of the measuring tool. Spirit levels 3 and 5 are

used only for alignment against walls. When laying floor

tiles, the bubbles of the spirit levels can be within the

marks, without the measuring tool being level.

Always use the centre of the laser line for marking. The

width of the laser line changes with the distance.

Never use the laser lines that the measuring tool standing

on the floor projects on the wall for alignment. The meas-

uring tool is not self-levelling. Therefore, the line on the wall

is distorted.

Bosch Power Tools

English | 17

1 609 929 T81 | (6.8.09)