Bosch 2 Manual del usuario e instrucciones de instalación - Página 35

Imprimir página

Bosch 2 Manual del usuario e instrucciones de instalación

Fault

"E:30 / -80"

"E:36 / -25 / -26"

"E:60 / -2B"

"E:30 / -10" and/or

lights up.

Cause and troubleshooting

Remove any unapproved extensions from the water

▶

hose.

→ "Connecting the appliance", Page 14

The pump cap is not fully screwed in.

Ensure that the pump cap is screwed in all the way

▶

into the appliance. The handle on the pump cap

must be in a vertical position.

Drain pump is blocked.

→ "Cleaning the drain pump", Page 31

▶

The unbalanced load detection system has interrupted

the spin cycle because the laundry is unevenly distrib-

uted.

Redistribute the laundry in the drum.

▶

Note: Where possible, mix large and small items in

the drum. Different sized items of laundry distribute

themselves better during the spin cycle.

The water pressure is low.

No remedial action possible.

The filters in the water inflow are blocked.

Clean the filters in the water inflow.

▶

The tap is turned off.

Turn on the tap.

▶

The water inlet hose is kinked or jammed.

Ensure that the water inlet hose is not kinked or

▶

jammed.

Water level measurement system is defective.

Note: With the error message, the appliance starts a

draining process.

First wait approx. 5 minutes until the drain process

ends.

To reset the error message, switch the appliance

off.

Switch the appliance back on.

If the error message is displayed again, call cus-

tomer service.

→ "Customer Service", Page 44

The temperature is too high.

Wait until the temperature has dropped.

▶

→ "Cancelling the programme", Page 29

▶

Water level is too high.

Troubleshooting en