Bosch 300 Series Manual de uso y mantenimiento / Instrucciones de instalación - Página 27

Navegue en línea o descargue pdf Manual de uso y mantenimiento / Instrucciones de instalación para Lavadora Bosch 300 Series. Bosch 300 Series 40 páginas. Built-in wall ovens
También para Bosch 300 Series: Manual de instrucciones (40 páginas), Manual del usuario (21 páginas), Manual de instalación (6 páginas), Manual de instalación (36 páginas), Manual de instalación (32 páginas), Manual de instrucciones (50 páginas), Manual de inicio rápido y seguridad (7 páginas), Manual de instalación (28 páginas), Manual de inicio rápido (7 páginas), Manual de uso y mantenimiento (32 páginas), Manual de inicio rápido y seguridad (7 páginas), Manual de servicio (36 páginas), Manual de inicio rápido y seguridad (13 páginas)

Imprimir página
Bosch 300 Series Manual de uso y mantenimiento / Instrucciones de instalación

Default Program and Option settings

At the factory initial settings are pre-set for all cycles.
You can change some program settings as follows.

Dry Level

This option adjusts the drying time in small steps for
certain programs.
Default setting = OFF (no LED Symbol shown)
Selectable values: OFF, +1, +2, +3
The Dry Level is retained until changed.
NOTICE: The higher the number value the increased
time of drying.

Time dry

Available only for Time programs,
~ Program selection table; Page 26
can be selected from minimum 20 minutes to maximum
3 hours, in 10-minute steps.

Additional Program Option settings

Wrinkle Block

If the Wrinkle Block option is activated it prevents the
laundry from creasing or wrinkling. The drum rotates at
specific intervals after the drying process allowing the
load to remain loose and fluffy until removed.
If the Wrinkle Block button is touched, this function is set
to 60 (+60m) or 90 (+90m) minutes.
The laundry remains loose and fluffy until it is removed.
The laundry should be removed before this time has
elapsed.

Low Heat

Reduced temperature for delicate fabrics, e.g.
polyacrylic, polyamide or elastane, with longer drying
time.
Observe the care information or symbols on the textile's
label.

Finish in

The program end (Finish in) time can be set in one hour
increments to a maximum of 24 h (hours).
After selecting the desired drying program (at the dial)
but before touching the Start button, touch the Finish in
button until the desired time is displayed, e.g. 8 h, then
touch the Start button to start the dryer.
NOTICE: The cycle duration is included in the set Finish
in time.
Here is an example of 1hr:30min cycle time and an 8 h
Finish in time. 8 h is displayed (until Energy-saving mode
activates) and counts down (approximately 6hr:30min)
until the drying cycle begins (at 1hr:30min) then the cycle
duration 1:30 is displayed and drying begins. Total time
approximately 8 hours.
27