Bosch 6 Series Manual de instrucciones - Página 11

Imprimir página

Removing and inserting the hook-in racks

You can remove the hook-in racks for easier cleaning.

Removing the hook-in racks

The hook-in racks are each fixed to the side panels of the

cooking compartment at three points.

Grip the front of the hook-in rack and pull it to the middle of

the cooking compartment.

The front hook of the hook-in rack will release from the hole.

Fold out the hook-in rack further and pull it from the rear

holes of the side panel.

Hold the catalytic cooking compartment panel in place.

Troubleshooting

Malfunctions often have simple explanations. Please read the

following notes before calling the aftersales service.

Problem

Possible cause Notes/remedy

The appliance

Circuit breaker

does not work.

faulty.

Power cut

The oven can-

The electronics

not be switched

are faulty.

off.

A beep sounds

The tempera-

every second.

ture probe is

faulty.

A beep sounds

The tempera-

twice per sec-

ture in the oven

ond.

interior is too

high.

The clock dis-

Power cut

play flashes.

The oven does

Circuit breaker

not heat up.

faulty.

The function

selector has not

been set.

The door glass

is broken.

Fruit juice or

Moist cake or

albumen stains

meat juices.

on enamelled

surfaces.

Risk of electric shock!

Incorrect repairs are dangerous. Repairs may only be carried

out by one of our trained after-sales engineers.

Incorrect repairs may result in significant risk to the user.

Look in the fuse box and

check that the circuit

breaker for the cooker is in

working order.

Check whether the kitchen

light works.

Switch off the circuit

breaker. Contact the after-

sales service.

Turn the function selector to

the Off position.

If the beeping persists when

setting a new heating func-

tion, switch off the appli-

ance and contact the after-

sales service.

Reset the clock.

Check the circuit breaker

and replace if necessary.

Set the function selector.

Switch off the appliance.

Contact the after-sales ser-

vice.

Harmless change in the

enamel, cannot be

removed.

Remove the hook-in rack from the cooking compartment.

Inserting the hook-in rack

Hold the catalytic cooking compartment panel in place.

Insert the hooks of the hook-in rack into the rear holes in the

side panel.

Press the front hook of the hook-in rack into the hole.

Replacing the oven light bulb

If the oven light bulb fails, it must be replaced. Replacement

heat-resistant bulbs can be obtained from the after-sales

service or from specialist retailers. Please specify the E number

and FD number of your appliance. Do not use any other type of

bulb.

Risk of electric shock!

When replacing the cooking compartment bulb, the bulb socket

contacts are live. Before replacing the bulb, unplug the

appliance from the mains or switch off the circuit breaker in the

fuse box.

Allow the cooking compartment to cool down.

Open the appliance door.

Place a tea towel in the cooking compartment to prevent

damage.

Remove the hook-in racks.

Remove the glass cover. To do this, open the glass cover at

the front with your hand. Should you experience difficulties

removing the glass cover, use a spoon to help.

Remove the oven light bulb.

Replace the oven light bulb with a bulb of the same type:

Voltage: 230 V;

Power: 40 W;

Fitting: G9;

Temperature resistance: 300 °C

Refit the glass cover for the oven light bulb.

Refit the hook-in racks.

Remove the tea towel.

10.

Switch the circuit breaker back on.

11.

Check that the oven lighting is working again.

12.