Bosch 8 Series Manual del usuario e instrucciones de instalación - Página 27

Imprimir página

Bosch 8 Series Manual del usuario e instrucciones de instalación

Fault

The control ring is dif-

ficult to turn.

The interior lighting

does not work.

Maximum operating

time reached.

A message with "D"

or "E" appears in the

display, e.g. D0111

or E0111.

The cooking result is

not satisfactory.

21.2 Replacing the oven light bulb

If the light in the cooking compartment fails, change

the oven light bulb.

Note: Heat-resistant, 40-watt, 230 V halogen bulbs are

available from the after-sales service or specialist retail-

ers. Only use these bulbs. Hold the new halogen bulbs

only with a clean, dry towel. This increases the service

life of the bulb.

WARNING ‒ Risk of burns!

The appliance and its parts that can be touched be-

come hot during use.

Caution should be exercised here in order to avoid

▶

touching heating elements.

Young children under 8 years of age must be kept

▶

away from the appliance.

WARNING ‒ Risk of electric shock!

When changing the bulb, the bulb socket contacts are

live.

Before replacing the bulb, ensure that the appliance

▶

is switched off in order to prevent a potential electric

shock.

Also unplug the appliance from the mains or switch

▶

off the circuit breaker in the fuse box.

Cause and troubleshooting

There is dirt below the control ring.

The control ring can be removed.

Note: To ensure that the mount remains stable, do not remove the control ring too often.

To loosen the control ring, press on the outer edge of the control ring.

a The control ring tilts and is easier to grip.

Remove the control ring from the mount.

Clean the control ring and its mount on the appliance carefully using soapy water and a

dish cloth. Dry with a soft cloth.

Do not use any harsh or abrasive cleaning agents.

Do not soak the control ring.

Do not clean the control ring in the dishwasher.

The halogen lamp is defective.

Change the oven light bulb.

▶

→ "Replacing the oven light bulb", Page 27

To prevent an unwanted permanent operation, the appliance automatically stops heating

after several hours if the settings are unchanged. A message appears in the display.

The point at which the maximum operating time is reached is determined by the corres-

ponding settings for an operating mode.

To continue the operation, press any touch field and turn the control ring.

If you do not need to use the appliance, use

Tip: To prevent the appliance from switching off when you do not want it to, set a cooking

time.

→ "Setting the cooking time", Page 13

The electronics have detected a fault.

Switch the appliance off and on again.

a If the fault was a one-off, the message disappears.

If the message appears again, call the after-sales service. Please specify the exact error

message when calling.

→ "Customer Service", Page 28

Settings were unsuitable.

Setting values, e.g. temperature or cooking time, depend on the recipe, quantity and food.

Next time, set lower or higher values.

▶

Tip: A lot of information about the food preparation and corresponding setting values

can be found on our website www.bosch-home.com.

⁠ to switch it off.

Requirements

¡ The appliance is disconnected from the power sup-

ply.

¡ The cooking compartment has cooled down.

¡ You have a new halogen bulb to replace the old one.

Place a tea towel in the cooking compartment to

prevent damage.

Turn the glass cover anti-clockwise to remove it ⁠ .

Pull out the halogen bulb without turning it ⁠ .

Insert the new halogen lamp and press it firmly into

the socket.

Make sure the pins are positioned correctly.

Troubleshooting en