Bosch Classixx 7 WAE28369GB Series Manual de instrucciones e instrucciones de instalación - Página 25
Navegue en línea o descargue pdf Manual de instrucciones e instrucciones de instalación para Lavadora Bosch Classixx 7 WAE28369GB Series. Bosch Classixx 7 WAE28369GB Series 36 páginas.
Imprimir página
Faults
Water not visible in the
drum.
Spin result not satisfac-
tory.
Laundry wet/too damp.
Spin cycle started and
stopped several times.
The programme duration
is longer than usual.
The programme duration
changes during the wash
cycle.
Residual water in the
compartment for care
products.
Odours in the washing
machine.
The N symbol flashes in
the display panel. Foam
may escape from the
detergent drawer.
Intense noise, vibrations
and "wandering" during
spinning.
Noises during spin and
drain cycles.
Display panel/indicator
lamps do not function dur-
ing operation.
Detergent residues on the
laundry.
NO appears on the dis-
play in reload mode.
Cause/remedial action
Not a fault – water below the visible area.
Not a fault – the unbalanced load detection system has interrupted the spin
■
because the laundry is unevenly distributed.
Distribute small and large items of washing in the drum.
Reduced Ironing selected?
■
Selected speed too low?
■
Not a fault – the unbalanced-load detection system is adjusting the imbalance.
Not a fault – the unbalanced-load detection system is adjusting the imbal-
■
ance by repeatedly distributing the laundry.
Not a fault – the foam detection system active – adds an additional rinse
■
cycle.
Not a fault – the programme sequence is optimised for the particular washing
process. This may lead to changes in the programme duration in the display
panel.
Not a fault – the effect of the care product is not affected.
■
Clean the insert if necessary ~ Page 21
■
Run Cottons 90 °C programme without washing.
Use standard detergent.
Too much detergent used?
Mix one tablespoon of fabric softener with 1/2 litre water and pour into com-
partment II (not for outdoor fabrics or those made with down).
Reduce the detergent dosage for the next wash cycle.
Are the appliance feet fixed? Secure the appliance feet. ~ Page 33
■
Transport locks removed? Remove the transport locks. ~ Page 30
■
Clean the detergent solution pump ~ Page 21
Power cut?
■
Circuit breakers tripped? Switch the circuit breakers back on or replace
■
them.
If the fault occurs repeatedly, call the after-sales service.
■
Occasionally, phosphate-free detergents contain water-insoluble residues.
■
Select Rinse/Spin or brush the laundry after washing.
■
Water level too high. Not possible to add laundry. Close the washing
■
machine door immediately, if necessary.
Select Start/Reload to continue the programme.
■
Faults and what to do about them.
en
25