Bosch FAP-OC 500Series Manual de uso y mantenimiento / Instrucciones de instalación - Página 18

Navegue en línea o descargue pdf Manual de uso y mantenimiento / Instrucciones de instalación para Lavadora Bosch FAP-OC 500Series. Bosch FAP-OC 500Series 40 páginas. Built-in wall ovens
También para Bosch FAP-OC 500Series: Manual de instrucciones de instalación (21 páginas), Manual de instrucciones (40 páginas), Manual de instalación (6 páginas), Información sobre el producto (40 páginas), Manual de instalación (28 páginas), Manual del usuario (48 páginas), Manual del usuario (48 páginas), Manual de instalación (28 páginas), Manual de uso y mantenimiento (44 páginas), Manual de instalación (32 páginas), Manual de consulta rápida (4 páginas), Manual de uso y mantenimiento (27 páginas), Manual de instalación (24 páginas), Manual de instalación (32 páginas), Manual de uso y mantenimiento (24 páginas), Manual de instalación (28 páginas), Manual de servicio (41 páginas), Manual de uso y mantenimiento (21 páginas), Manual de instalación (32 páginas), Manual de servicio (36 páginas), Manual de instalación (32 páginas), Manual de inicio rápido y seguridad (13 páginas)

Transporting the washer

Before transporting the washer

Disconnect the washer power cord from the wall

outlet.

Turn off the water supply to the washer.

Disconnect water supply lines from the tap.

Disconnect the drain hose from the drain location.

Install the transport bolt assemblies as shown in the

following images.

Remove the transport bolt hole covers

Remove all four transport bolt hole covers.

Pull the tip of the arrow on the cover out slightly to

disengage the locking tab.

Rotate the cover counterclockwise to remove. Repeat

for all 4 transport bolt hole covers.

Insert the transport bolt assemblies

Each assembly consists of a plastic bushing and a

bolt that extends through the bushings. Unscrew the

bolt until the threaded end is flush with the end of the

plastic bushing.

Insert the transportation bolt and bushing assembly as

shown. The metal housing slides around the bolt

through the slot in the plastic bushing as the bushing

is slid into place. The open part of the bushing slot

should be facing the direction shown to allow the

assembly to slide fully into place.

When the bolt is in place screw it in until the bolt

threads engage the drum. Double check and ensure

bolts are screwed into threaded holes and not into

cracks or crevices. Repeat the process for all 4

transportation bolt assemblies before tightening any all

the way. Complete tightening all 4 bolt assemblies

until they are each snug in place.