Bosch FAP-OC 500Series Manual de servicio - Página 27

Imprimir página

Bosch FAP-OC 500Series Manual de servicio

58300000202181 ARA EN B

TROUBLESHOOTING

The information in this section will be helpful when troubleshooting, diagnosing, and resolving faults and other issues affec ting the normal operation

of the oven.

7.1 Error Codes

A Service Guide/Wire Diagram that includes error code information is available in

QuickFinder and is also packed with every oven. Find it on the underside of the upper

plenum access panel as shown in Figure 37.

Additional error code information and suggested repair actions can be found in the

following table. Note that error codes which begin with E1 apply specifically to the

single/upper oven cavity, and those which begin with E2 apply specifically to the lower

oven cavity of double ovens.

Error Code Description

Wrong module code

E000

(E100/E400 internal errors

reported as E000)

E302

Control module too hot

E005

Communication error

E305

This material is intended f or the sole use of BSH authorized persons and may contain conf idential and proprietary inf ormation. Any unauthorized rev iew, use, copy ing, disclosure, or distribution in any f ormat is prohibited.

January 2017

Cause/Notes

Control module and user interface are

mismatched. No operation is possible.

Temperature sensor on the control module

detects temperature higher than limit value.

Control turns off heating elements and fan

defaults to high speed. When cavity

temperature lowers to 212°F/100°C, heating

will resume and error will be cleared. (If self-

clean was running, it will be disabled until a

control reset is performed.)

E005: Loss of communication between user

interface and control module.

E305: Loss of communication between TCM

and control module or TCM and user interface.

1901 Main St ▪ Suite 600 ▪ Irvine, CA 92614

Service Manual for Bosch 500 Series Built-in Wall Ovens

Figure 38 Location of Service Guide on the control module access panel

Suggested Action(s)

Enter correct option code in Service mode.

If cooling fan is not operating...

 Check connections to the fan and the

control module (see Small Load Schematic).

If cooling fan is operating...

 Check element operation

 Check for air obstruction or damaged

upper/lower ventilation trims

 Check for stuck relays.

 Check for damaged (cut or pinched) wires

or loose connectors.

 Confirm that voltage is getting to the

correct pins on the board.

Page 27 of 41

800 944-2904