Bosch FAP-OC 500Series Manual de servicio - Página 9

Navegue en línea o descargue pdf Manual de servicio para Lavadora Bosch FAP-OC 500Series. Bosch FAP-OC 500Series 36 páginas. Built-in wall ovens
También para Bosch FAP-OC 500Series: Manual de instrucciones de instalación (21 páginas), Manual de instrucciones (40 páginas), Manual de instalación (6 páginas), Información sobre el producto (40 páginas), Manual de instalación (28 páginas), Manual del usuario (48 páginas), Manual del usuario (48 páginas), Manual de instalación (28 páginas), Manual de uso y mantenimiento (44 páginas), Manual de instalación (32 páginas), Manual de uso y mantenimiento / Instrucciones de instalación (40 páginas), Manual de consulta rápida (4 páginas), Manual de uso y mantenimiento (27 páginas), Manual de instalación (24 páginas), Manual de instalación (32 páginas), Manual de uso y mantenimiento (24 páginas), Manual de instalación (28 páginas), Manual de servicio (41 páginas), Manual de uso y mantenimiento (21 páginas), Manual de instalación (32 páginas), Manual de instalación (32 páginas), Manual de inicio rápido y seguridad (13 páginas)

Bosch FAP-OC 500Series Manual de servicio
To remove the door...
1. Open door completely.
2. Flip hinge levers back to open as shown below.
Figure 6 Opening the hinge lever
3. Close door until it remains open ~6 inches.
4. Using both hands, lift door up and out.
To replace the door...
1. Position door as if it were open ~6 inches and insert hinges
into slots.
2. Open door completely.
3. Flip hinge levers forward to close as shown below.
Figure 7 Closing hinge lever
4. Close and open door to check operation.
Hinges should be replaced in pairs.
The 300, 500, and 800 series ovens do not have serviceable
hinge receivers.
4.2

Door Latch/Motor Assembly

The motorized door latch (MDL) mechanism (120V 5W) has 2
switches - the door switch and the lock/unlock switch. The latch will
automatically lock when mode and temperature selectors are set to
CLEAN, and unlock when the oven cools to ~490°F. It is serviced as
an assembly.
If the latch becomes stuck in the locked position, turning the unit off
and back on will open the latch if the cavity temperature <450°. If latch
is stuck in partially locked position, press
The latch can be tested in Service mode.
To remove the latch/motor assembly:
1. Remove 3 T20 screws securing trim piece to frame (do not
remove 2 screws on either side of latch).
2. Pull trim forward about 1", then slightly to the right or left to
clear the screw tab (see Figure 8).
3. Slip hands under trim and lift upper plate while sliding trim and
latch toward you.
Screw
Tab
Figure 8 Door latch/motor assembly
Service Manual for Bosch Built-in Wall Ovens
, then
SELF CLEAN
ON
Lock/
Door
Unlock
Switch
Switch
Page 9 of 36
/
.
OFF