Inicio
Marcas
Bosch
Lavadora
Bosch Programme Table
Manual de instrucciones de instalación y funcionamiento
Página 12

Bosch Programme Table Manual de instrucciones de instalación y funcionamiento - Página 12

Imprimir página

Bosch Programme Table Manual de instrucciones de instalación y funcionamiento

Washing programmes*

* depends on the model

Drying programmes

Special programmes

Sensitive s

For washing fabrics with increased hygiene requirements or those that will

be used by allergy sufferers. The temperature remains constant during the

washing process. More intensive rinsing with increased water level. For

hard-wearing and easy-care fabrics made from cotton or linen.

Night Wash S

Particularly quiet wash programme with a reduced final spin.

Sleep mode. Once the programme has finished, the display goes out, but

can be reactivated by pressing any button.

Intensive Dry 5

Intensive drying for a (robust fabrics), at 90°C.

Gentle Dry ‰

Gentle drying for ` (easy-care fabrics), 60°C.

Fluff Clean l

This programme is designed to clean the drying cycle of any fluff

deposits. After 10 drying cycles, the washer-dryer uses the symbol

(Fluff Clean) in the display panel to show that this programme should

be run. The electronic cycle counter is then automatically reset.

The

(Fluff Clean) symbol goes out after the programme starts.

To run the Fluff Clean

Make sure that the drum is completely empty and close the door.

Turn the programme selector to Fluff Clean

Press the A (Start/Pause) button.

The Fluff Clean

prompting by the appliance.

' + B Rinse + Spin

An additional rinse cycle with a final spin. If the laundry is to be removed

dripping wet, set the Schleuderdrehzahl (Spin speed) to $ (Rinse hold)

before Programme start –> page 13.

[ + B Drain + Spin

Drain the rinsing water following a programme with

$ (Rinse hold) –> page 13.

Turn the programme selector to [ + B Drain + Spin.

Set the spin speed to $ (Rinse hold).

Press the A (Start/Pause) button.

Drain and spin at the desired spin speed:

Turn the programme selector to [ + B Drain + Spin.

Press the B (Spin) button repeatedly until the desired spin speed is

set.

Press the A (Start/Pause) button.

, proceed as follows:

programme can also be run at any time without