Bosch Series 4 Manual de instrucciones - Página 7

Imprimir página

2Cleaning and maintenance

Warning – Risk of burns!

C l e a n i n g a n d m a i n t e n a n c e

The appliance becomes hot during operation. Allow the

appliance to cool down before cleaning.

Warning – Risk of electric shock!

Penetrating moisture may result in an electric shock.

Clean the appliance using a damp cloth only. Before

cleaning, pull out the mains plug or switch off the circuit

breaker in the fuse box.

Warning – Risk of electric shock!

Do not use any high-pressure cleaners or steam

cleaners, which can result in an electric shock.

Warning – Risk of injury!

Components inside the appliance may have sharp

edges. Wear protective gloves.

Cleaning agents

To ensure that the different surfaces are not damaged

by using the wrong cleaning agent, observe the

information in the table. Do not use any of the following:

Harsh or abrasive cleaning agents,

■

Cleaning agents with a high alcohol content,

■

Hard scouring pads or cleaning sponges,

■

High-pressure cleaners or steam cleaners.

■

Wash new sponge cloths thoroughly before use.

Follow all instructions and warnings included with the

cleaning agents.

Area

Cleaning agent

Stainless steel

Hot soapy water:

Clean with a dish cloth and then dry with a

soft cloth.

Clean stainless steel surfaces in the grind

direction only.

Special stainless steel cleaning products are

available from our after-sales service or from

specialist retailers. Apply a very thin layer of

the cleaning product with a soft cloth.

Painted surfaces

Hot soapy water:

Clean using a damp dish cloth and dry with a

soft cloth/towel.

Do not use any stainless steel cleaners.

Aluminium and plastic Glass cleaner:

Clean with a soft cloth.

Cleaning and maintenance

Area

Cleaning agent

Glass

Glass cleaner:

Clean with a soft cloth. Do not use a glass

scraper.

Controls

Hot soapy water:

Clean using a damp dish cloth and dry with a

soft cloth/towel.

Risk of electric shock caused by penetrating

moisture.

Risk of damage to the electronics from pene-

trating moisture. Never clean operating con-

trols with a wet cloth.

Do not use any stainless steel cleaners.

Removing and installing the filter

The filter must be serviced regularly in order to

guarantee efficient filtration of odours and grease.

Metal grease filter

The metal grease filters must be cleaned every

150 operating hours or at least every three months.

Warning – Risk of fire!

Fatty deposits in the grease filter may catch fire.

Clean the grease filter at least every 3 months.

Never operate the appliance without a grease filter.

Activated charcoal filter (only in circulating-air mode)

The activated charcoal filters must be changed at least

every 3 to 5 months.

Removing metal grease filter

The metal grease filters filter the grease out of kitchen

steam. To keep them in good working order, the filters

should be cleaned at least every 3 months.

Open the lock on the metal grease filters and

remove the filters from the retainer.

Notes

– When you do this, take hold of the metal grease

filters from underneath with your other hand.Make

sure that the metal grease filters do not fall and

damage the hob.

– Fat may accumulate in the bottom of the metal

grease filters. Hold the filters level to prevent fat

from dripping out.

Clean the metal grease filters.

Clean the inside of the appliance.