Bosch Series 4 Manual de instrucciones - Página 20

Imprimir página

Installation

During installation, make sure that the lettering "top right" is

upside down at the bottom left.

Insert the panel at an angle towards the back (fig. A).

Insert the top panel at an angle towards the back into the

brackets. The smooth surface must face outwards. (fig. B).

Troubleshooting

Malfunctions often have simple explanations. Refer to the table

before calling the after-sales service as you may be able to

remedy the fault yourself.

Malfunction table

If a dish doesn't turn out as well as you had hoped, refer to the

section Tested for you in our cooking studio, where you will

find plenty of cooking tips and tricks.

Risk of electric shock!

Incorrect repairs are dangerous. Repairs may only be carried

out by one of our trained after-sales engineers.

Problem

Possible cause Remedy/information

The oven does

The circuit

not work.

breaker is

defective.

Power cut

The clock dis-

Power cut

play flashes.

The oven does

There is dust on

not heat up.

the contacts.

The gas burner

Power failure or

does not ignite.

damp ignition

plugs.

Look in the fuse box and

check that the circuit

breaker is in working order.

Check whether the kitchen

light or other kitchen appli-

ances are working.

Reset the clock.

Turn the control knobs back

and forth several times.

Light the gas burner with a

gas lighter or a match.

Put the cover back in place and press on it.

Attach the oven door.

Do not use the oven again until the panels have been

correctly installed.

Replacing the bulb in the oven ceiling light

If the bulb in the oven light fails, it must be replaced. Heat-

resistant, 40 watt spare bulbs can be obtained from our after-

sales service or a specialist retailer. Only use these bulbs.

Risk of electric shock!

Switch off the circuit breaker in the fuse box.

Place a tea towel in the oven when it is cold to prevent

damage.

Unscrew the glass cover by turning it anti-clockwise.

Replace the bulb with one of the same type.

Screw the glass cover back in.

Remove the tea towel and switch on the circuit breaker.

Glass cover

You must replace a damaged glass cover. Suitable glass

covers may be obtained from the after-sales service. Please

specify the E number and FD number of your appliance.